Craftsman 17" Drill Press with Laser and LED Light Owner's Manual download pdf (Page 6)

CARTON CONTENTS

UNPACKING AND CHECKING CONTENTS

Carefully unpack the Drill Press and all its parts, and compare against the

illustration following.

WARNING:

• To avoid injury from unexpected starting, do not plug the power cord into a

power source receptacle during unpacking and assembly. This cord must

remain unplugged whenever you are assembling or adjusting the drill press.

• If any part is missing or damaged, do not plug the drill press in until the miss-

ing or damaged part is replaced, and assembly is complete.

• To protect the drill press from moisture, a protective coating has been applied

to the machined surfaces.

Remove this coating with a soft cloth moistened with kerosene .

WARNING: To avoid re or toxic reaction, never use gasoline, naphtha, acetone,

lacquer thinner or similar highly volatile solvents to clean the drill press.

TABLE OF LOOSE PARTS

Unpack carton; check the machine to see parts listed below:

A. Main parts :

See Fig. 1

1. Head assembly

2. Column Assembly

3. Table

4. Base

5. ON/OFF Switch

6. Flexible Lamp

To turn on drill press, lift paddle switch from bottom.

To turn off drill press, push paddle switch down.

To prevent unauthorized use, remove the center key from the

switch. Figure 1B and 1C

Drill press cannot be turned ON if key is not inserted.

FIGURE 1

ACCESSORIES AND ATTACHMENTS

FIGURE 1B FIGURE 1C

1 2 3 4 5 6 7 8 9 10 11 ... 33 34

No comments

Craftsman 17" Drill Press with Laser and LED Light Owner's Manual Page 6