Craftsman 137.218300 Operator's Manual download pdf (Page 10)

ASSEMBLE THE TABLE SAW TO THE STAND

(FIG. B)

1. Release the stand buckle (t) as shown.

2. Unfold the leg sets and push the two latches (2)

downward to lock them in place.

3. Place the stand on a level surface and adjust

the front-right adjustable foot, so all legs are

contacting the floor and are at similar angles on

the floor.

4. Match the holes of the stand to the holes on the

bottom flange of the saw base. (Fig. B)

5. Fasten the saw to the stand using the four hex.

head bolts (3) and the four flat washers (4)

provided, then tighten securely with a 17mm

wrench.

6. Position the saw on a clean, level surface.

Fig. B

ASSEMBLE THE HANDWHEEL HANDLE (FIG. C)

Thread the handwheel handle (1) into the handwheel

hole (2), and then tighten the nut against the

handwheel with a 10mm wrench. Note: If the handle

bolt becomes loose, remove the plastic end cap and

this will allow you to tighten securely.

Fig. C

INSTALLING THE REAR TABLE EXTENSION

(FIG. D)

1. Slide the two rear table extension tubes (2) into the

rear table extension (1).

2. Snap the two location seats (5) over the two rear

table extension tubes (2). Make sure the locating

pin in the location seat fits into the matching hole in

the extension tube.

3. Insert the rear table extension tubes (2) into the two

extension tube brackets under the table.

Position rear table support so the hole for the

rubber pad (7) is between the extension and the

table (see Fig. D).

4. Insert the bolt into the rear table extension (1).

The place the rubber pad (7) onto the bolt (8) and

tighten.

Fig. D

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

No comments

Craftsman 137.218300 Operator's Manual Page 10