Craftsman 133.33166 Operator's Manual download pdf (Page 8)

• Blade depth and bevel adjusting locking levers must be tight and secure

before making a cut. If the blade adjustment shifts while cutting, it may

cause binding and kickback.

• Use extra caution when making a "Plunge Cut" into existing walls or

other blind areas. The protruding blade may cut objects that can cause

kickback.

• Do not use the circular saw near fumes or combustible liquids.

• Secure small pieces of wood firmly before working. Never hold them

in your hand.

• Never slow the blade down with your hands or by applying pressure

to the side of the blade.

• Never apply force( Advance the circular saw gently and steadily.

EXTENSION CORDS

Replace damaged cords immediately. Use of damaged cords can shock,

burn or electrocute.

If an extension cord is necessary, a cord with adequate size conductors

should be used to prevent excessive voltage drop, loss of power or

overheating. The table shows the correct size to use, depending on cord

length and nameplate amperage rating of tool. If in doubt, use the next

heavier gauge. Always use U.L. and CSA listed extension cords.

RECOMMENDED SIZES OF EXTENSION CORDS

Tool's

Ampere

rating

Volts

3 - 6 120V~

6 - 8 120V~

8 - 10 120V~

10 -12 120V~

12 -16 120V~

Total length of cord in feet. Cord size in

A.W.G. (minimum)

25 ft

(7.6 m)

50 ft

(15 m)

16 16

16 14

100 ft 150 ft

(30 m) (46 m)

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 45 46

No comments

Craftsman 133.33166 Operator's Manual Page 8