Craftsman 113.24350 Owner's Manual download pdf (Page 9)

MOTORPULLEY BELT GUARD AND MOTOR

INSTAL LATION

MOUNTING BELT GUARD

1. Place the motor on your workbench with the shaft

facing you,

If you are using a double shaft motor, the 5/8" dia.

shaft must be facing you.

2. Attach guard support to the bracket with the two

screws, furnished with the guard,

NOTE: The holes in the bracket are not threaded, but the

screws are "thread cutting screws" and will cut a thread as

they are tightened.

BELT GUARD

SUPPORT BRACKET

TH READ CUTTI NG

SCREWS

BELT GUARD

SUPPORT

5/32 INCH

SETSCREW

WRENCH

MOUNTING PULLEY

1, Loosen setscrew in motor pulley and place the pulley on

the shaft with the hub flush with the end of the shaft,

insert the motor shaft key and tighten setscrew with

5/32" setscrew wrench.

When installing the pulley on a 1/2" diameter motor

shaft, make sure that the adapter sleeve and 3/16"

square key furnished with your motor are in place.

Then tighten the setscrew with a 5/32" setscrew wrench.

FLUSH HERE

3/16 x 3/16 KEY ,._

MOTOR

SHAFT

KEY

ADAPTER SLEEVE

1/2" DIA. MOTOR SHAFT

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

Craftsman 113.24350 Owner's Manual Page 9