Craftsman 113.24350 Owner's Manual download pdf (Page 8)

assembly

RUBBER GASKET

3. Peel off the protective covering from the rubber gasket

and stick it around the clamp. Make sure it extends

a little beyond each end of the clamp.

The gasket will help to prevent sawdust from leaking

out.

For the most efficient removal of sawdust, attach a

Craftsman Home-n-Shop Vac to the sawdust elbow.

(

TABLETRUNNION

INSTALLING TABLE

Remove the protective oiT that is applied to the table.

Use any ordinary household type grease and spot remover.

CAUTION: Never use gasoline, naptha or similar highly

volatile solvents.

Apply a coat of automobile wax to the table.

_N PIN

TABLE LOCK BOLT

1. Place the table on the band saw so that the two trunnion

pins and the table lock bolt go through the slot in the

trunnion.

2. Find the 1-1/8" dia. flat washer, a sleeve 11/16" long,

the trunnion lock nut and the table lock handle from

among the loose parts.

3. Hold the head of the table lock bolt inside the band saw

with your left hand and put the 1-1/'8" dia. flat washer,

the sleeve, and the handle on the bolt,

4, Screw the nut on the bolt and tighten it with the handle

while the table is in a horizontal position.

_NUT

TABLE LOCK BOLT TABLE LOCK HANDLE

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

No comments

Craftsman 113.24350 Owner's Manual Page 8