Craftsman 113.235100 Owner's Manual download pdf (Page 8)

Getting to Know Your Miter Saw

1. Warning label.

2. Stop Shaft - The miter saw can be locked in the

lowered position for compacl storage.

3, Miter Lock Knob - The miter lock knob securely

locks the miter saw at a desired miter angle, Index

points have heen provided at 0, 225 R/L, and 45

RiL.

4, Miter Index Spring Loosen Miter Lock Knob and

depress the index spring to move out of 0,22-1/2 ° &

45 ° indexes.

5. Bevel Lock Knob - The bevel Iock knob locks the

miter saw at a desired bevel angle. Model

113.235200 oniy.

6. Bevel Index Pin - This pin altows for quick 0 and

45° bevel settings. The pin may also be pulled out

far enough to override the stops. Model

113.235200 only.

7 Lower Blade Guard - The blade guard helps pro

tect your hands from the blade in the raised posi

lion. To avoid binding on the workpiece it retracts

as the blade is lowered.

8. Miter Saw Switch Handle - The saw handle con-

tains the trigger switch with a lock-off buttcn. The

blade is lowered into the workpiece by pushing

down on the handle. The saw witl return to its

upright position when the handle is released

9. On-Off Trigger Switch - To prevent the trigger

from being accidentally engaged, a lock-off button

is provided. To start the tool, push the !ock-off but-

ton forward and squeeze the trigger. Release the

trigger to stop the miter saw.

10 Padlock Hole - A hole in the switch trigger and

handle has been provided so that a padlock (not

supplied) could be attached to prevent unautho-

rized use.

MITER SAW

SWITCH HANDLE

WARNING LABEL

BASE

1!. Miter Saw Carry Handle - After locking the power

head in the lowered position with the stop shaft the

saw is conveniently carried using this handle

12. Cover Plate Stop Screw - When this screw is

loosened, the cover plate is rotated to the rear,

allowing for blade removal/replacement,

13. Arbor Lock (Model 113.235200 Only) - Allows the

user to keep the blade from rotating while tighten- 7,

mg or loosening the arbor screw during bladeLOWER BLADE

replacement or removal. GUARD

14. Combination Wrench Used for !/4" hex and

phillips head screw adjustments, Storage is provid-

ed as shown.

15. Base - Supports table, holds accessories and

allows for workbench or legset mounting.

FENCE

TRIGGER SWITCH

11.

MITER SAW

CARRY HANDLE

14.

COMBINATION

WRENCH

POWER CORD

ELBOW

BEVELINDEX

PiN MODELt13,235200ONLY

BEVELLOCKKNOB

MODEL113.235200 ONLY

UPPER BLADE

GUARD

12.

COVER PLATE

STOP SCREW

LOCK OFF

BUTTON

SPRING

10.

PADLOCK

HOLE

13,

ARBOR LOCK

MITER LOCK KNOB

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

Comments to this Manuals

No comments

Craftsman 113.235100 Owner's Manual Page 8

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.235100