Craftsman 113.235100 Owner's Manual download pdf (Page 6)

Motor Specifications and Electrical Requirements (Continued)

DANGER: To avoid electrocution:

1, Use only identical replacement parts when

servicing a tool with double insulation.

Servicing should be performed by a qualified

service technician,

2. Do not use in rain or where floor is wet.

This tool is intended for indoor residential use

only.

Motor Safety Protection

IMPORTANT: To avoid motor damage, this motor

should be blown out or vacuumed frequently to keep

sawdust from interfering with normal motor ventilation.

1. Connect this tool to a 120v, 15-amp branch circuit

with a 15-amp time delay fuse or circuit breaker.

Using the wrong size fuse can damage the motor.

2. If the motor won't start, release the trigger switch

immediately. UNPLUG THE TOOL. Check the saw

blade to make sure it turns freely, if the blade is free,

try to start the motor again. If the motor still does not

start, refer to the "Motor Trouble-Shooting Chart."

3. If the motor suddenly stalls while cutting wood,

release the trigger switch, unplug the tool, and free

the blade from the wood. The motor may now be

restarted and the cut finished.

4. Fuses may "blow" or circuit breakers may trip fre-

quently it:

a. Motor Is Overloaded-Overloading can occur if

you feed too rapidly or make too many start/stops

in a short time.

b. Line voltages are more than 10% above or below

the nameplate voltage. For heavy loads, however,

the voltage at motor terminals must equal the volt-

age specified on nameplate.

5. Most motor troubles may be traced to loose or incor

rect connections, overload, tow voltage (such as

small size wire in the supply circuit) or to overly long

supply circuit wire. Always check the connections.

the load and the supply circuit whenever motor

doesn't work well. Check wire sizes and length with

the Wire Size Chart below.

Wire Sizes

NOTE: Make sure the proper extension cord is used

and is in good condition.

The use of any extension cord will cause some loss of

power. To keep this to a minimum and to prevent over-

heating and motor burn-out, use the table below to

determine the minimum wire size (A.W.G) extension

cord.

Length of the Wire Sizes Required for 120v

Conductor {American Wire Gage Number)

110-120V

0-25 14

26-50 12

Table of Contents

Section Page

Warranty .......................................................................... 2

Safety Instructions for Miter Saw ............................... 2_4

Glossary of Woodworking Terms ................................... 5

Motor Specifications and

Electrical Requirements ............................................ 5-6

Unpacking and Checking Contents ................................ 7

Tools Needed ................................................................ 7

Unpacking ................................................................ 7

List of Loose Parts ........................................................ 7

Getting to Know Your Miter Saw .................................... 8

Section Page

Assembly .................................................................. 9

Alignment ............................................................. 10-1!

Mounting the Miter Saw .......................................... ! 2-13

Safety Instructions for Basic Saw Operations ....... 14-16

Basic Saw Operations ............................................ 16-21

Maintenance and Lubrication .................................. 22

Sears Recommends the Following Accessories ........ 23

Trouble Shooting Gu*de ........................................ 24-25

Repair Parts .......................................................... 26-31

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

Comments to this Manuals

No comments

Craftsman 113.235100 Owner's Manual Page 6

Comments to this Manuals

Related products and manuals for Power tools Craftsman 113.235100