Craftsman 310 Repair Manual download pdf (Page 20)

310-0510 IHT

18

Figure 10. Seal Kit Replacement

SEAL KIT REPLACEMENT

Before disassembly, wipe the unit free of any

debris to avoid contamination.

Refer to Figure 10.

Axle Seal

1. Remove the axle clips (93) from the axle

horns (for units with keyed axle shafts).

2. Remove the seal retaining rings (12).

3. Carefully pull the axle seals (34) out of the

housing bore with a “hook” type tool. Care

must be taken to avoid damage to the hous-

ing bore or to the shaft sealing areas.

4. Lubricate the new seal with petroleum jelly

prior to installation.

5. Wrap the shaft keyway (splines) with cello-

phane to prevent damage to the seal lip dur-

ing installation.

6. Slide the seal over the shaft and press it in-

to the housing bore.

7. The seal should seat against the sleeve

bearing.

8. Install the seal retaining rings (12).

9. Install the axle clips (93), if applicable.

Input Seal

1. Remove the input pulley and fan from the

input shaft.

2. The seal (13) can be replaced by following

steps 2-6 of the procedure used to replace

the axle seals.

Trunnion Seal

1. Remove the control arm and any attach-

ments to the control arm. See page 17.

2. The seal (17) can be replaced by following

steps 3-6 of the procedure used to replace

the axle seals.

Brake Seal

1. Remove the brake assembly and any at-

tachments to the brake assembly. See page

16.

2. The seal (74) can be replaced by following

steps 3-6 of the procedure used to replace

the axle seals. Install a new retaining ring

(74).

Bypass Seal

1. Remove the bypass arm and any attach-

ments to the bypass arm. See page 16.

2. The seal (51) can be replaced by following

steps 3-6 of the procedure used to replace

the axle seals.

34

13

93

12

51

74

17

34

93

12

12

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 39 40

Comments to this Manuals

No comments