Craftsman 315.220730 Owner's Manual

Owner's ManualCRRFTSMRWTwo Speed / Reversible10 mm (318 in.) CORDLESSDRILLStock No._922073Model No.315.220730Save this manual forfuture reference

INSTALLINGBITSSee Figure 6.• Lockthe switchtdgger byplacingthe directionofrotationselector in canter position.See Figure 3.• Open or closechuck jaws t

,_ WARNING: Alwayswear safety gogglesorsafetyglasses withside shieldswhen operatingtools, Failure to do so couldresult in objectsbeingthrownintoyour e

CHUCK REMOVALSee Figures 10, 11, and 12.The chuck must be removed in orderto use someaccasscdes. To remove:• Leck the switchtrigger by placingthe dire

_k WARNING: When servicing,use onlyIdenticalCraftsman reptacementparts. Use of anyotherpart may create a hazard or cause productdamage,Avoid usingsolv

14

CRAFTSMAN 10 mm (3/8 In.) CORDLESS DRILL MODEL NO. 315.220730[The model numberwill be foundon a plate attached tothe motor housing.Always mentionthe I

Owner's ManualSTOCK NO. a 22073MODEL NO. 315.220730Sears service is available at or throughyour Sears Retail Storeor Catalogue Sales Office.How t

• Warranty ...

The purpose of safety symbols is to attract your attention to possible dangora. The ssfoly symbols, andthe explanations with them, deserve your carefu

RULES FOR SAFE OPERATION (Continued)MMmMNEVER USE IN AN EXPLOSNE ATMO-SPHERE. Normal sparkingof the motor couldigniteflammable liquids,gases, or fumes

RULESFORSAFEOPERATION(ConUnued)An extensioncord shouldnot be used unlessabsolutelynecessary. Usa of improperextensioncord couldresult in a riskof fire

KNOW YOUR DRILLSee Figure 1.Before attemptingto usa any toolfamiliarizeyourselfwithall operatingfeatures and safetyrequirements,WRIST STRAPSee Figure

A WARNING: Always wear safetygogglesorsafetyglasseswith side shieldswhen operatingtools. Failure to do so couldresult in objectsbeingthrownIntoyour ey

SWITCHSee Figure2.To turnyourdrill ON, depress the switchtdgger. Toturn it OFF, releasethe switch trigger.SELECTORCENTERPosmoN(LOCK)TRIGGERFig. 2TWO S

TOINSTALLBATTERYPACK• Lockswitchtriggeron yourddll byplacingthedirectionof rotation selector incanter position.See Figure 3.• Place battery back inyou