Craftsman 137.212260 Operator's Manual download pdf (Page 34)

34 35

34 35

Ceiling/Wall (Crown Molding Orientation)

Orientation

Inside corner Outside corner

Right

side of

wall

Left

side of

wall

Right

side of

wall

Left

side of

wall

Cut on this

side of the saw

Left Right Left Right

4. Use the clamp to secure the molding

piece and hold it at the proper spring

angle.

NOTE: Use the extension wings to

steady long molding pieces.

5. Cut on the side of the saw as shown

in the following chart.

NOTE: If molding piece is too tall,

cut ﬂat using the instructions of a

conventional way on page 35.

Cutting base molding:

Base moldings and many other

moldings can be cut on your miter

saw. The setup of the saw depends on

molding characteristics and application.

Perform practice cuts on scrap material

to achieve best results.

1. Place the base molding piece upside

against the fence and table as

shown in Fig. KK.

2. Measure the angle of corner by

angle ﬁnder and lock the sliding

fences unit in positions.

3. Use the clamp to secure the base

molding piece.

NOTE

: Use the telescoping

extension wings to support long

molding pieces.

4. Cut on the side of the saw as shown

in the following chart.

Wall/Ground (Base Molding Orientation)

Orientation

Inside corner Outside corner

Right

side of

wall

Left

side of

wall

Right

side of

wall

Left

side of

wall

Cut on this

side of the saw

Right Left Right Left

NOTE: If molding piece is too tall, reset

fences to 0° and cut ﬂat using the bevel

like a conventional saw.

Fig. KK

miter at 45º, bevel at 0º

Workpiece

F

e

n

c

e

Miter Saw Table

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 47 48

Comments to this Manuals

No comments