Craftsman 137.212260 Operator's Manual download pdf (Page 17)

16 17

16 17

ASSEMBLY AND ADJUSTMENTS

WARNING



!

To avoid injury from unexpected

starting or electrical shock, do not

plug the power cord into a source

of power during unpacking and

assembly. This cord must remain

unplugged whenever you are

working on the saw.

To avoid injury and damage to the

saw, transport or store the miter saw

with the cutting head locked in the

down position. Never use the head

lock down knob to hold the cutting

head in a down position for cutting

operations.

CUTTING HEAD (FIG. A)

Raising the Cutting Head

1. Push down slightly on the switch

handle (1).

2. Pull out the head lock down knob (2)

out of the locking hole (3).

3. Pull up the switch handle (1) to raise to

the up position.

FIG. A

Locking Cutting Head in Down

Position(FIG. A)

When transporting or storing the miter

saw, the cutting head should always be

locked in the down position.

1. Push the switch handle (1) down to

its lowest position.

WARNING



!

2. Push out the head lock down knob (2)

into the locking hole (3).

IMPORTANT: To avoid damage,

never carry the miter saw by the switch

handle or the cutting arm.

INSTALLING THE DUST BAG (FIG. B)

1. Squeeze the metal collar wings (2) of

the dust bag (1).

2. Place the dust bag neck opening

around the exhaust port (3), and

release the metal collar wings.

FIG. B

INSTALLING THE CLAMP (FIG. C)

NOTE: The clamp is used to secure the

workpiece during cutting operations.

1. Install the clamp on the saw by

inserting the ﬁxed shaft (1) into one

of the holes (2) provided in the miter

saw base.

FIG. C

1

2

3

1

2

1

3

2

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 47 48

Comments to this Manuals

No comments