Operator's ManualModel No. 486.25012®PRINTED IN U.S.A. FORM NO. 42482 (05/09/12)Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.www.sears
10• Assemble the latch stand plate and latch stand bracket (with alignment tab toward rear of cart) to thecarttrayusingfour1/4"x3/4"
115/16" x 3/4"HEX BOLT(SELF TAP)WING NUTNYLON WASHERHOSE HANGERRODHOSE CLAMPHOSEHOSE ADAPTER(NOZZLE)FIGURE 8FIGURE 9FIGURE 10• Place the ho
12TRACTOR HITCH FRAME (SQUARE) HITCH PLATE TRACTOR HITCH FRAME (TAPERED) 1/2" x 1-1/4"HEX BOLT7/16" FLAT WASHER 1/2" NYLOCK NUTA
13BENDBOTTOM OFCART COVERLOWERSUPPORT RODROPEBOTTOM SLEEVEFIGURE 15• Slide the second lower support rod (bent ends) through the sleeve along the bott
141/4" x 1-1/4"HEX BOLT1/4" FLANGEDNUTBRACE1/4" x 3/4" HEX BOLT1/4" FLANGEDNUTLOWER SUPPORTROD (BENT)1/4" LOCKNUTFI
15• Allow the rope to hang loosely behind the rear of the cart.Usethelanyardtotightentheropeuntilitrmlysecuresthecartcovertothecart
16FIGURE 27• Holding the adapter bracket and the deck adapter together, position the deck adapter on the mower deck. Keeping the edge of deck adapter
17• Assemble the adapter bracket to the deck using two 5/16"x1-1/4"hexbolts,5/16"atwashersand5/16"nylocknuts.Seegu
18THROTTLE CONTROL Controls speed of engine.CHOKE CONTROLAdjusttoallowcoldstarting.FUEL SHUT-OFFShutsofffuelowtoengine.ON-OFF SWITCH T
19HOW TO USE YOUR VAC SYSTEMHOW TO START YOUR VAC SYSTEM• Check oil and gas in Vac engine.• Attach spark plug wire to spark plug.• Move choke lever
2TABLE OF CONTENTS MODEL NUMBER: 486.25012 SERIAL NUMBER: __________________ DATE OF PURCHASE: __________________The model number and serial
20MAINTENANCEService Dates Check for loose fasteners X Check cover X Check tire pressure X Check engine oil level X Lubricate X Cl
21PROBLEM POSSIBLE CAUSE(S) CORRECTIVE ACTIONEngine fails to start 1. Spark plug wire disconnected. 1. Connect wire to spark plug.2. Safety switch
226 167 19 20 17 9 6 10 12 53211518 8 4 21 13 26 23 23 14 1822 11 25 25 24 23 39302728REPAIR PARTS LIST FOR 486.25012 VAC
23REPAIR PARTS LIST FOR 486.25012 VACREF. NO.PART NO. QTY. DESCRIPTION1 48791 1 Cart Tray2 65518 1 Rope,36"3 43012 4 HexBolt,1/4-20x3/4"
244011723221411581381313826262626262525252527272710101034323334354136ADAPTER #6246813202128252543731218123118322831616159839729261324303839312519See
25REPAIR PARTS FOR MODEL 486.25012 VACREF. NO.PART NO. QTY. DESCRIPTION1 27144 1 Top Support Angle2 25874 1 Front Support Tube3 25876 2 Brace4 49873 2
26REF. NO.PART NO.QTY. DESCRIPTION1 629-0241A 1 Harness, Wire2 24634 1 Housing Assembly, Inner3 24633 1 Housing Assembly, Outer4 43182 12 HexBolt,5/
27WARNING: To avoid serious injury, operate your tractor up and down the face of slopes, never across the face. Do not operate on slopes greater than
PARTS ORDERING/SERVICE ® Registered Trademark / TM Trademark of KCD IP, LLC in the United States, or Sears Brands, LLC in other countries ® Marca R
3SAFETYAnypowerequipmentcancauseinjuryifoperatedimproperlyoriftheuserdoesnotunderstandhowtooperatetheequipment.Exercisecautiona
4 WARNINGTO AVOID SERIOUS INJURY• Read Owner’s Manual and all safety labels on machine before starting and using machine.• Do Not remove top cove
5The Hand Wand Attachment, Model 486.24509 providesa12'x5"diameterhosetocleanaround shrubs, patios, window wells and other areas no
6FULL SIZE HARDWARE CHART (CART)NOT SHOWN FULL SIZEA BCDEGRSNLMJTPHFOQZXYWAAKUVIREF. NO.PART NO. QTY. DESCRIPTIONA 47407 1 HexBolt,5/16-18x4"
7FULL SIZE HARDWARE CHART (ADAPTER)NOT SHOWN FULL SIZEDEFHGA BIJKMNLCREF. NO.PART NO. QTY. DESCRIPTIONA 1509-90 3 HexBolt,1/4-20x1-1/4"B 4384
8CARTON CONTENTS12861419152116242725182628171123731045121392022REF. NO.PART NO. QTY. DESCRIPTION1 48791 1 Cart Tray2 40343 1 Cart Cover3 41310 1 Engin
9ASSEMBLY• Assemble the rear tongue to the wheel support by slidingtheaxlethroughtheholesinthetongueandwheelsupportasshowningure3.5/
Comments to this Manuals