Craftsman 944.602951 User Manual Page 25

  • Download
  • Add to my manuals
  • Print
  • Page
    / 56
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 24
TROUBLESHOOTING POINTS
PROBLEM
CAUSE CORRECTION
Will not start
1. Out of fuel.
1. Rll fuel tank.
2.
Engine not ‘CHOKED’ properly.
2.
See TO START ENGINE” in Operation section.
3.
Engine flooded. 3. Wait several minutes before attempting to start
4. Bad spark plug. 4. Replace spark plug.
5. Dirty air filter. 5. Clean/replace £tir filter.
6.
Dirty fuel filter.
6. Replace fuel filter.
7. Water In fuel. 7. Drain fuel tank and carburetor, refill tank with fresh
gasoline and replace fuel filter.
8.
Loose or damaged wiring.
8.
Check ail wiring.
9.
Carburetor out of adjustment
9. See To Adjust Carburetor" in Service Adjustments
section.
10. Engine valves out of adjustment. 10. Contact an authorized service center/department.
Hard to start
1.
Dirty air filter.
1. Clean/replace air filter.
2. Bad spark plug. 2. Replace spark plug.
3.
Weak or dead bafiety. 3. Recharge or replace battery.
4.
Dirty fuel filter.
4.
Replace fuel filter.
5.
Stale or dirty fuel. 5. Drain fuel tank and refill with fresh gasoline.
6. Loose or damaged wiring. 6.
Check all wiring.
7. Carburetor out of adjustment. 7.
See To Adjust Carburetor" In Service Adjustments
section.
8. Engine valves out of adjustment 8.
Contact an aufiiorized service center/department.
Engine will not turn over 1. Brake pedal not depressed. 1. Depress dutch/brake pedal.
2. Attachment clutch is engaged. 2. Disengage attachment clutch.
3.
Weak or dead battery.
3. Recharge or replace battery.
4. Blown fuse. 4. Replace fuse.
5. Corroded battery terminals. 5. Clean battery tenninds.
6.
Loose or damaged wiring.
6.
Check all wiring.
7. Faulty Ignition switch. 7.
Check/replace Ignition switch.
8. Faulty solenad or starter.
8.
Check/replace solenoid or starter.
9. Faulty operator presence switch(es). 9.
Contact an authorized service center/department.
Engine clicks but will not
1.
Weak or dead battery.
1.
Recharge or replace battery.
start 2. Corroded battery terminals.
2.
Clean battery temninals.
3. Loose or damaged wiring. 3. Check all wiring.
4.
Faulty solenoid or starter.
4. Check/replace solenoid or starter.
Loss of power 1. Cutting too much grass/too fast. 1.
Set in “Higher CuT position/reduce speed.
2. Throttle in “CHOKE" position. 2. Adjust throttle control.
3. Build-up of grass, leaves and trash under mower. 3. Clean underside of mower housing.
4. Dirty air filter. 4. Clean/replace air filter.
5.
Low oil level/dirty oil.
5. Check or! level/change oil.
6. Faulty spark plug.
6. Clean and regap or change spark plug.
7. Dirty fuel filter. 7. Replace fuel filter.
8. Stale or dirty fuel. 8. Drain fuel tank and refill with fresh gasoline.
9. Water in fuel.
9.
Drain fuel temk and carburetor, refill tank with fresh
gasoline and replace fuel filter.
10. Spark plug wire loose. 10.
Connect and tighten spark plug wire.
11.
Dirty engine air screen/fins. 11. Clean engine air screen/fins.
12. Dlrty/clogged muffler. 12. Clean/replace muffler.
13.
Loose or damaged wiring. 13.
Check all wiring.
14.
Carburetor out of adjustment. 14.
See To Adjust Carburetor” in Service Adjustments
section.
15.
Engine valves out of adjustment 15. Contact an authorized service center/department.
Excessive vibration
1.
Worn, bent or loose blade. 1. Replace blade. Tighten blade bolt.
2. Bent blade mandrel. 2. Replace blade mandrel.
3. Loose/damaged part(s). 3. Tighten loose part(s). Replace damaged parts.
25
Page view 24
1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 55 56

Comments to this Manuals

No comments