Craftsman 315.108620 Operator's Manual download pdf (Page 21)

A WARNING: Before performing any adjustment,

remove blade from saw. Failure to do so could result

in possible serious personal injury,

A WARNING: DO NOT point the laserat yourself

orothers,ClassIlia laserswillbum the retinasand

could cause sedousinjuryto the eyes.

A CAUTION: Use of controls or adjustments or

performance other than those specified herein may

result in hazardous radiation exposure,

ADJUS'NNG THE REAR LASER

See Figures 24 - 25.

NOTE: The rear laser is the only laser on the tool designed

to be realigned.

The rear laser can be realigned by adjusting the two

screws located in the back of the upper blade guard. The

top screw moves the laser beam laterallyfrom left to right.

The bottom screw moves the laser beam in a rotational

direction°

NOTE: Draw a pencil line on scrap workpiece parallel to

the long edge of the base as a stralght line guide to atd in

the adjusting process,

[] Remove the blade, dust nozzle, and dust nozzle adap-

tor if installed.

I Plug in the saw.

[] Turn laser on.

[] Rest the back of the base on scrap workpiece.

[] Adjust screws as necessary.

I Stnce blade thicknesses vary, always make a trial cut In

scrap workplace to ensure an accurate cut,

[] Check for proper alignment.

[] Repeat as necessary until laser is aligned.

REMOVEDUSTKNOZZLE

\ \iS/N .

t I

lopi

Fig. 25

1 2 ... 16 17 18 19 20 21 22 23 24

No comments

Craftsman 315.108620 Operator's Manual Page 21