MAKING A BEVEL CUT
See Figure20
" HoTdthe sawfirmlywithbothhandsas shown,
i Restthe front edgeofthe baseonthe workpieceo
i Startthe saw and let the bladereach full speed°
m Guidethe saw intothe workpiece andmake the cut,
[] Releasethe switch trigger and allow the bladeto come
to a completestop,
[] Lift the sawfrom the workpiece,
Fig, 20
POSITIVE 0° BEVEL STOP
See Rgum 21o
,_lk WARN|NG: Failureto unplug the tool couldresult in
accidental starting causingseriouspersonal injury.
The saw has a positive 0° bevel stop that has been factory
adjusted to assure 0° angle of the saw blade when making
90° cuts.
CHECKING POSITIVE 0° BEVEL STOP
[] Unplug the circularsawr
= Placethe sawin an upside downposition on a work-
bench,
[] Check the squarenessof thesawbladeto the base of
thesaw usinga carpenter's square.
ADJUSTING POSITIVE 0° BEVEL STOP
[] Unplug the circularsaw.
[] Lift beve_adjustment_everup,
[] Turn setscrew with hex key and adjust base until it is
squarew_ththe sawb}ade.
[] Lowerbevel adjustmentleveruntilmotorhousing is
lockedinto place.
_ WARNING: Attempting a bevelcutwithouthaving
the beveladjustmentleversecurelytightenedcan
resultinseriouspersonalinjury°
CARPENTEIt'S
SETSCREW
Fig.21
19
Comments to this Manuals