Craftsman 247.346250 User Manual

OWNER’SMANUALMODEL NO. 247.346250Caution;Read and Follow All Safety Rules and Instructions Before Operating This EquipmentCRAFTSMAN5.0 HORSEPOWER 2

Remove the quick release pin which secures the jack stand. Support the tongue, and pivot the jack stand up against the tongue. Secure with the

NOTE: Before initial use or first time use after storage, be certain to fill the reservoir as instructed in next section.IMPORTANT: Reservoir t

OnPositionFuei Shut-Off ValveFast PositionThrottleOn PositiohEngine Shut-Off SwitchPositionCHOKETO STOP ENGINEMove throttle control lever to SLOW posi

GENERAL RECOMMENDATIONSHex BoltsAWARNING: ALWAYS STOP THE ENGINE AND DISCONNECT THE SPARK PLUG WIRE BEFORE PERFORMING ANY MAINTENANCE OR ADJUSTME

Your four-cycle engine will normally consume some oil; therefore, check engine oil level regularly— approximately every five hours of

MUFFLERDo not operate the log splitter without a muffler or tamper with the exhaust system. Damaged mufflers or spark arresters could crea

SERVICE AND ADJUSTMENTSFLEXIBLE PUMP COUPLERThe flexible pump coupler is a nylon “spider” insert, located between the pump and engine shaft. O

NOTE: A dirty air cleaner will cause engine to run rough. Be certain air cleaner is clean and attached to the carburetor before adjusting

TROUBLE SHOOTINGPROBLEMPOSSIBLE CAUSE(S) CORRECTIVE ACTIONEngine fails to start• Engine shut-off switch OFF.• Fuel shut-off valve closed.• Fuel tan

HYDRAULIC TROUBLE SHOOTING GUIDEProblemProbable Cause(s)Corrective ActionCylinder rod will not moveA Broken driveshaft B Loose shaft coupling C Gear s

IMPORTANTSAFETY RULESATHIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH, IF NOT FOLLOWED, COULD ENDANGER THE PERSONAL SAFETY AND/OR PROPERTY

SEARS CRAFTSMAN 5 H.P. LOG SPLITTER MODEL NO. 247.346250Repair Parts20

SEARS CRAFTSMAN 5 H.P. LOG SPUTTER MODEL NO. 247.346250Repair PartsKEYNO.PARTNO.DESCRIPTIONKEYNO.PARTNO.DESCRIPTION1712-0359Slotted Nut 3/4-16 Thd.46

BRIGGS AND STRATTON 5 H.P. ENGINE MODEL NO. 133402-0011-01Repair PartsREF.N0.PARTNO.DESCRIPTION1 495133Cylinder Assembly2399268Bushing-Cylinder3*29981

BRIGGS AND STRATTON 5 H.P. ENGINE MODEL NO. 133412-0059-01Repair PartsREF.NO.PARTNO.DESCRIPTION12‘270080 Gasket-Crankcase (.015" Thick, Std.)•270

BRIGGS AND STRATTON 5 H.P. ENGINE MODEL NO. 133402-0011-01Repair PartsREF.NO.PARTNO.DESCRIPTION51 *272295Gasket-Carburetor Mtg.52 ‘272585Gasket- Intak

BRIGGS AND STRATTON 5 H.P. ENGINE MODEL NO. 133402-0011-01Repair PartsREF.NO.PARTNO.DESCRIPTION5494705Screw-Hex.Head28494620 Screw-Hex. Hd.300494562Mu

BRIGGS AND STRATTON 5 H.P. ENGINE MODEL NO. 133402-0011-01Repair PartsREF.NO.PARTNO.DESCRIPTION55494846Housing-Rewind Starter56493824Pulley-Rewind Sta

BRIGGS AND STRATTON 5 H.P. ENGINE MODEL NO. 133402-0011-01Repair PartsREF.NO.PARTNO.DESCRIPTION3*299819 Seal-Oil7*272157Gasket-Cylinder Head9*27549Gas

OWNER’SMANUALMODEL NO. 247.346250HOW TO ORDER REPAIR PARTSCRAFTSMAN®S HORSEPOWER 25.5 TONHYDRAULIC LOG SPUTTEREach log splitter has its own mode

2. Know how to stop the unit and disengage the controls.3. Never place hands or teet between log and splitting wedge or between log and end plate du

CONGRATULATIONS on your purchase of a Sears Craftsman log splitter. It has been designed, engineered and manufactured to give you th

TABLE OF CONTENTSSAFETY RULES...2,3PRODUCT SPECIFICATIONS...4CUSTOMER

ASSEMBLY INSTRUCTIONSWheels and Reservoir TankAssemblyWedge, Beam and Cylinder AssemblyTongue and Hitch AssemblyJackStandmFIGURE 1.Wedge, Beam and Cyl

ReturnHosefigure 6.• Turn the wedge, beam and cylinder assembly around 180° degrees so the wheels and reservoir tank assembly can be easily at

OPERATIONKNOW YOUR LOG SPLIHERREAD THIS OWNER’S MANUAL AND SAFETY RULES BEFORE OPERATING YOUR LOG SPLITTER. Compare the illustrations wi

TO STOP ENGINE• Move throttle control lever to SLOW position.• Move engine shut-otf switch to OFF position. See figure 7.• Disconnect spark plug