Craftsman 486.244050 User Manual

Owner's ManualCRRFTSMRNAG CARTModel No. 486.244050CAUTION:Before using this product,read this manual and followall Safety Rules andOperating Inst

KNOW YOUR CARTRead this owner's manual and safety rules before operating your cart.Compare the illustra_on below with your cart to familiarize yo

IMPORTANT: Do Not Exceed 2,000 lb. capacity ofcart. One cubic foot of dirt weighsapproximately !50 Ibs.Do not unhook your cart from the tractor while

REPAIR PARTS FOR MODEL 486.244050273322\27\®/2682202627 \_\ _ / 359\ _363412321315/27/21412O\22\84646 1830/12

REPAIR PARTS FOR MODEL 486.244050REF.NO.1234567891011121314151617181920212223242526272829303132333435363738394O41424344454647PARTNO.243542349023484235

NOTES14

&CAUTION: Do not operate your tractor and cart on a slope inexcess of 10 degrees. Be sure of your tractor's towing and brakingcapabilities be

For in-home major brand repair service:Call 24 hours a day, 7 days a week1-800-4-MY-HOME °"(1-800-469-4663)Para pedir servicio de reparaci6n a do

SAFETY RULES ... 3FULL SIZE HARDWARE CHART ... 4CARTON CONTENTS ...

Any power equipment can cause injury if operated improperly or if the user does not understand how to operatethe equipment. Exercise caution at all ti

HARDWARE SHOWN FULL SIZEBBREF.ABCDEFGHIJKLMNQTY.224166272234268534DESCRIPTIONREF. IQTY, DESCRIPTION,=xBolt, 1/2-13 x 4-1/2" Lg.,_xBolt, 3/8-16 x

153CARTON CONTENTS1. Tailgate2. Tailgate Reinforcement Bracket3. Cart Bed (2)4. Front Panel5. Wheel Support6. Axle, Rear7. Front Axle Support8. Front

&CAUTION: Do not leave the cart unat-tended in an upright position. A falling cartcan cause injury. Pay close attention to thestability of the car

Standthecartonend,frontendfacingup.Assemble the two front axle supports to the cartusing eight 5/16"x 3/4" slotted bolts, 5/16" lockwas

Assemble the tongue reinforcement angle to the backside of the front axle supports as shown in figure g.Use two 5/16" x 2-1/2" hex bolts, 5/

Assemble a cotter pin to the inside hole in an axlespindle. Next place a 3/4" flat washer, a wheel (valvestem facing out) and another 3/4" f