Craftsman Strut Spring Compressor Tool with Built-In Safety Pins Owner's Manual download pdf

MacPherson Strut Coil Spring Tool

Model No. 47057

IMPORTANT:

• Only use on MacPherson strut springs with coil wire diameters of

.625 inch or less

• Always use latch locking pins

• Always wear protective eyewear

• Follow all instructions

Instructions for Use:

The spring tool consists of two rod-and-latch assemblies. On each

rod there is an upper and lower latch. The upper latch contains a

locking pin.

Lubricate the rod threads with 30W oil before each use. Retract the

upper latch locking pins by pulling

back on them. Hook the upper and lower latches over the top and

bottom coils of the spring as shown. See Figure 1. Push in the lock-

ing pins to lock the upper latches onto the top coil of the spring. The

two rod-and-latch assemblies should be attached exactly opposite

each other on the spring.

Begin compressing the spring by nger-tightening the bolts atop the

upper latches on each side. After

each side is snug, perform the rest of the tightening with a hand

wrench or air wrench. Alternately tighten one side a short distance

and then the other to assure equal compression on both sides.

Keep

tightening back and forth until the springs are sufciently clear of

the spring seats. See Figure 2.

Now perform repairs on strut as necessary following the automotive

manufacturer’s recommended procedures.

Once repairs are complete and the tool-compressed spring is cor-

rectly positioned, alternately loosen the upper latch bolts equal

short distances from one side to the other until the spring is fully

decompressed.

CAUTION: To avoid injury, do not remove locking pins from upper

latches until spring is fully decompressed.

FULL UNLIMITED WARRANTY

If this Craftsman Hand Tool ever fails to provide complete satisfac-

tion, return it to the nearest Sears

store or Craftsman outlet and it will be replaced, free of charge.

This warranty gives you specic legal rights, and you may also

have other rights which vary from state to state.

Sears, Roebuck and Co., Dept. 817WA,

Hoffman Estates, IL 60179

Summary of Contents

Page 1

MacPherson Strut Coil Spring ToolModel No. 47057IMPORTANT:• Only use on MacPherson strut springs with coil wire diameters of .625 inch or less• Always

Comments to this Manuals

No comments

Craftsman Strut Spring Compressor Tool with Built-In Safety Pins Owner's Manual

Browse online or download Owner's Manual for Unknown Craftsman Strut Spring Compressor Tool with Built-In Safety Pins. Craftsman Strut Spring Compressor Tool with Built-In Safety Pins Owner's Manual User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Unknown Craftsman Strut Spring Compressor Tool with Built-In Safety Pins