ASSEMBLY
1. Replace the spool (1) with a new pre-wound
spool.
2. Insert the end of line through the opening (4) in
the spool housing (3).
3. Align the tabs on the spool cover with the slots in
the spool housing on the trimmer head.
4. Push down on the spool cover locking it to the
spool housing.
5. To advance the line when initially installed, you
must pull the line while pressing the black line
release button on the side of the spool housing (3).
See Replacement Parts section for part number
and ordering information. Replacement Spool:
Purchase Spool Model# 64212 at a Sears store or
at Sears.com.
1. Cut a length of .065" (1.65 mm) nylon
monolament line (1) approximately 18’ (5.5 m)
long.
Insert end of line into the small hole (2) of an empty
spool to anchor the line.
3. Wind the line evenly and tightly in a clockwise
direction.
4. DO NOT wind the line beyond the edge (3) of the
spool.
5. Insert the line through hole (4) in the spool
housing.
6. Position line spool (5) in spool housing (6).
IMPORTANT! The battery pack is not charged
when it is purchased. Before using the trimmer for
the rst time, place the battery pack in the battery
charger and charge. Make sure to read all safety
precautions, and follow the instructions in the the
Battery Charger section.
1. Press the latch button (1) on the battery pack
down and hold.
2. Grasp the trimmer(2) rmly, and pull the battery
pack out of the hadle.
Note: The battery pack ts into the handle snugly
in order to prevent accidental dislodging. It may
require a strong pull to remove it.
1. Align the tongue (3) of the battery pack with the
cavity in the string trimmer rear handle housing
2. Grasp the trimmer(2) rmly.
3. Push the battery pack into the handle until the
latch locks into place.
4. Do not use force when inserting the battery pack.
It should slide into position and “click”.
Follow these instructiong in order to avoid
injury and to reduce the risk of electric shock
or re:
TO REPLACE THE SPOOL:
TO REFILL THE SPOOL:See Figure 6, page ii.
BATTERY
To removeSee Figure 7, page ii.
To install
■ Replace the battery pack or the charger
immediately if the battery case or charger
cord is damaged.
■ Verify that the switch is in the OFF position
before inserting or removing the battery
pack.
■ Verify that the battery pack is removed
and the switch is in the OFF position
before inspecting, adjusting, or performing
maintenance on any part of the trimmer.
■ Read, understand, and follow the
instructions contained in the section
entitled Charging Procedure.
8 — English
WARNING:
(56 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals