Craftsman 152.217050 Operations Instructions download pdf (Page 24)

ADJUSTING TABLE GUBS

Gibs are internai mechanisms that take up any piay

between the base and the infeed and outfeed tames.

Precise gib adjustment is done at the factory and

shouid not require any further adjustments. However,

if adjustments are required, phase follow instructions

bebw.

Fig. 21-1

B A A C

WARNING: DISCONNECT JOINTER/PLANER

FROM POWER SOURCE.

Loosen each of the bck nuts (A) on the backside

of the infeed (B) and outfeed tames (C). See

Figure 21-1.

Loosen the infeed tame bck, bcated on the front of

the infeed tame and the outfeed tame thumbqock

screw, bcated on the back of the outfeed tame.

Turn aH set screws (D) in until they bottom out,

fingertight. Do not over-tighten set screws as this

wHi make raising and bwering tames difficuit.

See Figure 21-1.

Recheck piay in the table gibs. If table is difficult to

raise or lower, loosen set screws. If there is still too

much play in gibs, continue tightening set screws.

6. Tighten lock nuts without letting set screws turn.

CHANGUNG MOTOR VOLTAGE

MAKE CERTAIN the Jointer/Haner is disconnected

from the power source before working on motor.

Have a certified electrician make all electrical connec-

tions. All local and state codes must be maintained.

The motor supplied with the Jointer/PDner is a dual

voltage 120/240-voit, single phase motor. The motor is

wired from the factory for 120-voit operation. To change

to 240-voit operation for your Jointer/Haner, proceed

with the following instructions. It is also necessary to

replace the 120 volt plug, supplied with the Jointed

Planer, with a UL/CSA Listed plug (not included) suit°

able for 240 volts and the rated current of the motor.

The Jointer/Haner with a 240 volt plug should only be

connected to an outlet having the same configuration

as the plug. No adapter is available or should be used

with the 240 volt plug.

1, Make sure switch is OFF and disconnect power

cord from power source,

2, Remove the front panel and verify on the motor tag

that motor is dual voltage,

3. if motor tag states that it is dual voltage remove

junction box cover on motor.

4, Using wiring diagram on inside of junction box

cover, reconnect motor leads for 240-volt operation,

5, Replace junction box cover and reassemble front

panel,

6, Replace 120 volt plug with a UL/CSA Listed 240

volt plug rated for current of the motor,

7. The ON/OFF switch is a 4-pole switch and does not

need any modifications.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 59 60

Comments to this Manuals

No comments

Craftsman 152.217050 Operations Instructions Page 24

Comments to this Manuals

Related products and manuals for Power planers Craftsman 152.217050