Craftsman FS2000 Owner's Manual download pdf (Page 11)

11 – English

DRY-FIRE LOCKOUT

The dry-fire lockout feature keeps the tool from operating

when fasteners are low in the magazine.

The low nail indicator window in the magazine shows how

many nails remain in the tool.

When the magazine has 0-5 nails remaining, the dry-fire

lockout feature will not allow continued operation.

To resume operation, reload the tool with nails.

LED WORKLIGHTS/DIAGNOSTIC FEEDBACK

See Figure 10, page ii.

The LED Worklights provide feedback to indicate whether

the battery pack is charged sufficiently and/or if the tool is

functioning properly.

To turn on the worklights, press the LED worklight grip

switch while firmly holding tool in normal operating posi-

tion.

If worklights are flashing, install fully charged battery. If

lights continue to flash, see Troubleshooting section for

more information.

REMOVING A JAMMED BRAD NAIL

See Figure 11, page ii.

WARNING: Remove the battery pack before remov-

ing nails or clearing a jammed nail. Failure to do so

could result in serious personal injury.

 Remove battery pack from the tool.

 Open magazine and remove nails.

 Pull up on the latch and open the jam release.

 Insert a flat blade screwdriver into the tip of the driving

mechanism and push the driver mechanism back,

freeing the nail jam.

 Remove the bent nail.

 Close the jam release and latch.

 Reinstall nails and close the magazine.

 Reinstall the battery, reactivate tool.

NOTE: Driving too deeply into the material, excess debris,

or jammed nails may lead to a driver blade being stuck at

its bottom position.

The driver blade can usually be returned to its operating

position by depressing the work contact element against a

scrap piece of wood and squeezing the trigger.

OPERATION

WARNING:

This product and some dust created by power sanding, sawing, grinding, drilling, and other

construction activities may contain chemicals, including lead, known to cause cancer, birth defects or other

reproductive harm. Wash hands after handling. Some examples of these chemicals are:

• lead from lead-based paints,

• crystalline silica from bricks and cement and other masonry products, and

• arsenic and chromium from chemically-treated lumber.

Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure

to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust

masks that are specially designed to filter out microscopic particles.

CALIFORNIA PROPOSITION 65

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Comments to this Manuals

No comments

Craftsman FS2000 Owner's Manual Page 11

Comments to this Manuals

Related products and manuals for Nail Gun Craftsman FS2000