Craftsman 21237 Owner's Manual download pdf (Page 18)

18 19

To avoid injury, do not connect this

miter saw to the power source until

it is completely assembled and

adjusted and you have read and

understood this Operator’s Manual.

CUTTING HEAD (FIG. A)

Raising

1. Push down slightly on the trigger

switch handle (1).

2. Pull out the hold-down latch (2).

3. Raise the cutting head to the

uppermost position.

NOTE: This cutting head is spring

loaded.

To avoid injury and damage to the

saw, transport and store the miter

saw with the cutting head locked in

the down position. Never use the

hold-down latch to hold the cutting

head in a down position for cutting

operations.

Fig. A

1

2

ASSEMBLY

WARNING



!

Locking

When transporting or storing the miter

saw, the cutting head should always be

locked in the down position.

1. Push the cutting head down.

2. Press the hold-down latch (2) in

to lock.

IMPORTANT: To avoid damage, never

carry the miter saw by the trigger

switch handle or the cutting arm.

INSTALLING THE MITER HANDLE

(FIG. B)

1. Thread the miter handle (1) into the

hole (2) located at the front of the

miter table.

Fig. B

INSTALLING THE DUST BAG (FIG. C)

1. Install the dust bag (1) onto the

exhaust port (2) on the miter saw.

Fit the connecting tube of dust bag

assembly and the exhaust port

together.

NOTE:

●

The dust bag assembly should be

angled toward the right side of the

saw for best results. This will also

avoid any interference during the

saw operation.

WARNING



!

1

2

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 53 54

Comments to this Manuals

No comments