Craftsman 536.772101 Operations Instructions download pdf (Page 11)

OPERATION

_IL ARNING: When the engine

runs, the blade will rotate. To

prevent injury, keep hands and

feet away from blade.

HOW TO STOP THE EDGER

1. Move the depth control lever forward to

raise the blade. Then, release the engine

stop lever. See Figure 8.

_lb WARNING: Never leave the

Edger unattended while the en-

gine is running. Always raise

the cutting blade and stop the engine.

HOW TO USE

THE ENGINE STOP LEVER

1. Release the engine stop lever and the

engine and the blade will automatically

stop. To run the engine, hold the engine

stop lever in the operating position. See

Figure 8.

2. If the engine continues to run, move the

throttle control to the STOP position.

IMPORTANT: Before you start the engine,

operate the engine stop lever several

times. Make sure the engine stop cable

moves freely. If the engine stop cable is

bent or damaged, replace the cable. If the

problem continues, take the Edger to a

Sears Service Center to correct the prob-

lem.

HOW TO USE

THE DEPTH CONTROL LEVER

1. Start the engine.

2. To lower the cutting blade, pull the depth

control lever back.

3. Select the edging depth that you need.

There are three selections with an

approximately depth of two inches.

NOTE: For deep edging, first cut at shal-

low depths. Then, cut at greater depths

until the desired depth is obtained.

Engine Stop Lever

(Operating Position)

Figure 8

HOW TO USE

THE PRIMER BUTTON

When starting a cold engine, push the prim-

er button five times (see Figure 9). Wait

approximately two seconds between each

push.

IMPORTANT: When starting a warm en-

gine, do not use the primer button.

HOW TO USE

THE THROTTLE CONTROL

1. Push the throttle control forward to in-

crease engine speed, or pull back to de-

crease engine speed (see Figure 9).

F=OO1101M

2. During normal use, run the engine at full

speed.

11

Throttle

Primer

Button Figure 9

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 30 31

Comments to this Manuals

No comments