Craftsman 57915 Owner's Manual Page 33
- Page / 92
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
ADJUSTMENT STEP 2
Test the Safety Reversal System
TEST
1. With the door fully open, place a 1-1/2 inch (3.8 cm) board (or
a 2x4 laid flat) on the floor, centered under the garage door.
2. Press the remote control push button to close the door. The
door MUST reverse when it makes contact with the board.
ADJUST
l If the door stops and does not reverse on the obstruction, the
down travel needs to be increased (refer to Adjustment
Step1). NOTE: On a sectional door, make sure adjustments
do not force the door arm beyond a straight up and down
position.
l Repeat the test.
l When the door reverses on the 1-1/2" (3.8 cm) board (or 2x4
laid flat), remove the obstruction and run the opener through
3 or 4 complete travel cycles to test adjustment.
l If the garage door opener continues to fail the safety reversal
test, call a trained door systems technician.
IMPORTANT SAFETY CHECK:
Test the Safety Reverse System after:
l Each adjustment of door arm length, limits, or force controls.
l Any repair to or adjustment of the garage door (including
springs and hardware).
l Any repair to or buckling of the garage floor.
l Any repair to or adjustment of the opener.
Without a properly installed safety reversal system, persons
(particularly small children) could be SERIOUSLY INJURED or
KILLED by a closing garage door.
l Safety reversal system MUST be tested every month.
l After ANY adjustments are made, the safety reversal system
MUST be tested. Door MUST reverse on contact with 1-1/2"
(3.8 cm) high object (or 2x4 laid flat) on the floor.
1-1/2" (3.8 cm) board
(or a 2x4 laid flat)
ADJUSTMENT STEP 3
Test The Protector System
®
1. Press the remote control push button to open the door.
2. Place the opener carton in the path of the door.
3. Press the remote control push button to close the door. The
door will not move more than an inch (2.5cm), and the
opener lights will flash.
The garage door opener will not close from a remote control if the
LED in either safety reversing sensor is off (alerting you to the
fact that the sensor is misaligned or obstructed). If the garage
door opener closes the door when the safety reversing sensor is
obstructed (and the sensors are no more than 6" (15cm) above
the floor), call for a trained door systems technician.
Without a properly installed safety reversing sensor, persons
(particularly small children) could be SERIOUSLY INJURED or
KILLED by a closing garage door.
Safety Reversing Sensor
Safety Reversing Sensor
31
- 139.57915 1
- Thank you 2
- SMART CONTROL 3
- TABLE OF CONTENTS 4
- INTRODUCTION 5
- Unattended Operation 5
- Preparing your garage door 5
- Test the Wi-Fi 6
- Tools needed 6
- Planning 7
- Planning (Continued) 8
- Carton Inventory 9
- Hardware Inventory 10
- ASSEMBLY STEP 1 11
- ASSEMBLY STEP 2 11
- ASSEMBLY STEP 3 12
- Install the Idler Pulley 12
- Tighten the Belt 13
- ASSEMBLY STEP 4 13
- Install the Belt 13
- ASSEMBLY STEP 5 13
- ASSEMBLY STEP 6 14
- Install the Sprocket Cover 14
- INSTALLATION 14
- INSTALLATION STEP 1 15
- INSTALLATION STEP 2 16
- Install the Header Bracket 16
- INSTALLATION STEP 3 17
- RELEASED 18
- Release Arm 18
- INSTALLATION STEP 5 19
- Hang the Opener 19
- INSTALLATION STEP 6 20
- Install the Lights 20
- INSTALLATION STEP 7 20
- INSTALLATION STEP 8 21
- Fasten the Door Bracket 21
- INSTALLATION STEP 9 23
- Connect Door Arm to Trolley 23
- INSTALLATION STEP 10 24
- Attach the Warning Labels 24
- INSTALLATION STEP 11 25
- Install the Door Control 25
- INSTALLATION STEP 12 26
- Install The Protector System 26
- (Continued) 27
- INSTALLATION STEP 13 29
- Electrical Requirements 29
- INSTALLATION STEP 14 30
- UP (Open) 31
- DOWN (Close) 31
- ADJUSTMENT STEP 1 32
- Program the Travel 32
- ADJUSTMENT STEP 2 33
- ADJUSTMENT STEP 3 33
- Test The Protector System 33
- SMARTPHONE CONTROL 34
- Get Connected 34
- IMPORTANT SAFETY INSTRUCTIONS 35
- 16. SAVE THESE INSTRUCTIONS 35
- Features 36
- Door Control 37
- Programming 39
- To Erase the Memory 40
- To Open the Door Manually 41
- Care of Your Opener 41
- TROUBLESHOOTING 42
- REPAIR PROTECTION AGREEMENTS 43
- REPAIR PARTS 44
- Motor Unit Assembly Parts 45
- Accessories 46
- Smart Control Accessories 46
- Warranty 46
- 1-888-331-4569 47
- ACCESORIOS 49
- GARANTÍA 49
- RESOLUCIÓN DE PROBLEMAS 50
- Posición con el seguro 52
- (desconexión manual) 52
- Para reconectar 52
- Para borrar la memoria 53
- Programación 54
- Control de la puerta 56
- Funciones 57
- 16. CONSERVE ESTAS 58
- INSTRUCCIONES 58
- CONTROL POR TELÉFONO 59
- INTELIGENTE 59
- AJUSTES, PASO 2 60
- AJUSTES, PASO 3 60
- AJUSTES, PASO 1 61
- ARRIBA (Abierta) 62
- ABAJO (Cerrada) 62
- INSTALACIÓN PASO 14 63
- INSTALACIÓN PASO 13 64
- Figura 5 65
- Figura 6 65
- Figura 7 65
- Figura 9 65
- Figura 8 65
- Instale la Protector System 66
- (continua) 66
- INSTALACIÓN PASO 12 67
- INSTALACIÓN PASO 11 68
- INSTALACIÓN PASO 10 69
- INSTALACIÓN PASO 9 70
- INSTALACIÓN PASO 8 72
- INSTALACIÓN PASO 6 73
- INSTALACIÓN PASO 7 73
- Figura 1 74
- Figura 2 74
- Figura 3 74
- CONECTADO 75
- Brazo de 75
- INSTALACIÓN PASO 3 76
- INSTALACIÓN PASO 2 77
- INSTALACIÓN PASO 1 78
- Tornillo hexagonals 79
- MONTAJE PASO 4 80
- MONTAJE PASO 5 80
- MONTAJE PASO 3 81
- MONTAJE PASO 1 82
- MONTAJE PASO 2 82
- Inventario de piezas 83
- Planificación (continuación) 85
- Planificación 86
- Herramientas necesarias 87
- INTRODUCCIÓN 88
- Verifique la 91
- Control inteligente 91
- Instalación 91
© 2020, manymanuals.com. All rights reserved. | 0.593 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals