Craftsman 358.797341 Instruction Manual download pdf (Page 5)

VACUUM ASSEMBLY

VACUUM BAG ASSEMBLY

1. Open tile zipper on the vacuum

bag and insert the elbow tube.

2. Push the small end of the elbow

tube through the small opening in

the bag.

Elbow

Tube

Small

Opening

Zipper

Opening Rib

NOTE: Make sure edge of the small

opening is flush against the flared area

of the elbow tube, and the rib on the

elbow tube is on the bottom.

3. Close the zipper on the bag. Make

sure the zipper is closed completely.

4. Remove blower tube from engine.

i Rib

5. Insert the elbow tube into the blow-

er outlet. Make sure elbow tube is

aligned with the blower outlet

groove.

6. Turn clamp knob clockwise to tight-

en.

VACUUM TUBE ASSEMBLY

1. Align tile lower vacuum tube as

shown. Push lower vacuum tube

into upper vacuum tube.

Upper

Vacuum Tube

Lower

Vacuum Tube

2. Insert a screwdriver into the latch

area on the vacuum inlet cover.

[L_,_ _ _'-_ BlOwer

] _,, Outlet

,_ ,.a_" Latch Area

vacuum

/ Inlet Cover

3. Gently tilt the handle of the screw-

driver toward the back of the unit

while pulling up on the vacuum in-

let cover with your other hand.

4. Hold the vacuum inlet cover open

until upper vacuum tube is installed.

Vacuum Inlet

Retaining Post X/_

wouo

Inlet _._7,_q_-_

Cover _.._

5. Place the hooks on the vacuum tube

on the retaining posts; pivot tube into

position. Secure vacuum tube by

turning the knob clockwise until tight.

Hooks

6. When converting back to the blow-

er feature, make sure latch on the

vacuum inlet cover is securely fas-

tened.

-5-

1 2 3 4 5 6 7 8 9 10 11 12 13

Comments to this Manuals

No comments