Craftsman 390.2511 Owner's Manual download pdf (Page 2)

READ AND FOLLOW SAFETY INSTRUCTIONS!

WARNING I

i CAUTION !

This is the safety alert symbol. When you see this symbol

on your pump or in this manual, look for one of the fol-

lowing signal words and be alert to the potential for per-

sonal injury:

DANGER warns about hazards that will cause serious per-

sonal injury, death or major property damage if ignored.

WARNING warns about hazards that will or can cause se-

rious personal injury, death or major property damage if ig-

nored.

CAUTION warns about hazards that will or can cause

minor personal injury or property damage if ignored.

The label NOTICE indicates special instructions which are

important but not related to hazards.

Carefully read and follow all safety instructions in

this manual and on pump.

Keep safety labels in good condition.

Replace missing or damaged safety labels.

Electrical Safety

A WARNING

Hazardous voltage.

Can shock, burn, or

cause death.

Ground pump before

connecting to power

supply.

_k Wire motor for correct

voltage. See "Electrical"

section of this manual.

and motor nameplate.

_k Ground motor before

connecting to power

supply.

_k Meet National Elect-

rical Code and local

codes for all wiring.

Follow wiring instruc-

tions in this manual

when connecting mo-

tor to power lines.

Make workshops childproof; use padlocks and master

switches; remove starter keys.

-General-Safety---

Donot allow pump, pressure tank, piping, or any other sys-

tem component containing water to freeze. Freezing may

damage system, leading to injury or flooding. Allowing

pump or system components to freeze will void warranty.

General Safety

WARNING

Hazardous pressure!

Install pressure relief

valve in discharge pipe.

Release all pressure on

system before working on

any component.

Relief valve must be capable of passing full pump flow at

75 PSI.

Pump water only with this pump.

Periodically inspect pump and system components.

Wear safety glasses at all times when working on pumps.

Keep work area clean, uncluttered and properly lighted;

store properly all unused tools and equipment.

Keep visitors at a safe distance from the work areas.

[AWARNING]pun)p body may explode if used as a

booster pump unless relief valve capable of passing

full pump flow at 75 PSI (517 kPa) is installed.

]Motor can operate at high temperature and

will be too hot to touch. It is protected from heat damage

during operation by an automatic internal cutoff switch.

Before handling pump or motor, stop motor and allow it to

cool for 20 minutes.

1 2 3 4 5 6 7 ... 19 20

Comments to this Manuals

No comments

Craftsman 390.2511 Owner's Manual Page 2

Comments to this Manuals

Related products and manuals for Water pumps Craftsman 390.2511