Craftsman 30 LED Rechargeable Stick Light Owner's Manual Page 2

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 1
8. To reduce the risk of electric shock, do not put in water or other liquid. Do not
place or store appliance where it can fall or be pulled into a tub or sink. NEVER ATTEMPT TO PICK UP
PLUGGED-IN APPLIANCES WHEN THEY FALL INTO WATER BECAUSE FATAL ELECTROCUTION COULD RESULT.
9. Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage
or stress.
10. Do not operate fixture if it has received a sharp blow, been dropped, or otherwise damaged in any way.
11. The direct plug-in charger is intended to be correctly oriented in a vertical or floor mount position.
12. This fixture MUST ALWAYS BE USED in accordance with all electrical and safety codes and ordinances, including
the most recent National Electric Code (NEC) and with the Occupational Safety and Health Administration (OSHA)
Volume 1 on General Industry Standards and interpretations.
13. DO NOT replace batteries.
14. DO NOT dispose of this product in fire. Batteries inside this product may explode or leak.
15. NiMH batteries must be disposed of in accordance with local waste ordinances and regulations.
16. DO NOT short the positive-negative terminals together.
17. DO NOT work on this battery pack.
18. DO NOT disassemble fixture. The fixture does not have any user serviceable parts.
19. This product is not intended to be repaired by service personal in case of failure or component defect
(unit can be thrown away).
20. This product must not be disposed of together with domestic waste. This product has to be disposed at an
authorized place for recycling of electrical and electronic appliances.
21. NEVER operate the light with the clear protective lens removed.
22. KEEP AWAY from excessive heat or flame.
23. DO NOT look directly into the light.
24. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation. The changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorientorrelocatethereceivingantenna.
• Increasetheseparationbetweentheequipmentandreceiver.
• Connecttheequipmentintoanoutletonacircuitdifferentfromthattowhichthereceiverisconnected.
• Consultthedealeroranexperiencedradio/TVtechnicianforhelp.
OpeRatiOn
1. Press switch in the handle up to turn the LED lights on high output.
2. Press switch in the handle down to turn the LED lights on low output.
3. Press switch to the middle to turn the fixture OFF.
Page view 1
1 2

Comments to this Manuals

No comments