Craftsman 152.211640 Operations Instructions download pdf (Page 13)

USING THE WHEEL DRESSER

(Fig. M)

Fig. M

The Wheel Dresser is to be used on the grinding

wheeb, it will remove buildup up of matedal on the

grinding wheel, remove imperfections and make the

corners of the grinding wheel square. See Figure M.

DO NOT use the Wheel Dresser on the Wire Wheel,

Make sure the right side tool rest (A) is in the fiat

horizontal position as shown and 1/16" away from

the grinding wheel.

Turn "ON" the Bench Grinder. Let the grinding wheel

After the grinding wheel has gotten to a steady

speed, place the Wheel Dresser (B) fiat on the

Tool Rest with the serrated wheels facing the

grinding wheel.

Firmly hold on to the handle of the Wheel Dresser.

Move the Wheel Dresser forward until the serrated

wheels make light contact with the grinding wheel.

After contact has been made, slide the Wheel

Dresser side to side across the Tool Rest to dress

the grinding wheel until the edge of the grinding

wheel is square and the surface is clean.

After the operator has completed dressing the

grinding wheel, turn "OFF" the Bench Grinder and

let the grinding wheel come to a complete stop,

inspect the grinding wheel for any damage!

The grinding wheel may now be slightly smaller in

diameter after dressing, Readjust the tool rests and

spark arrestors to maintain a 1/16" clearance to the

grinding wheel,

CHANGING THE GRINDING WHEEL

(Fig. N) C

Fig. N

H I G

Due to normal wear, both wheels will need to be

replaced occasionally,

1, Turn the power switch OFF and unplug the power

cord from its power source,

2, Rotate the eyeshield up to access the tool rest,

3, Loosen the tool rest knob and rotate the tool rest

away from the grinding wheel,

4, Turn Quick Release Knob (A) counter-clockwise to

remove knob from guard completely, See Figure N,

5, Rotate the Quick Change Wheel Cover (B) back

about 1/4-inch to release it from the inner Wheel

Guard (O),

Fig. O

Place a Crescent Wrench (D) (not included), Figure

O, on the arbor hex nut (E), Figure N, Place the

box end of the Special Wrench (F), Figure 0

(included with your grinder) onto the fiats of the

arbor shaft (G),

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 35 36

Comments to this Manuals

No comments

Craftsman 152.211640 Operations Instructions Page 13

Comments to this Manuals

Related products and manuals for Straight grinders Craftsman 152.211640