Craftsman 88780 Owner's Manual download pdf (Page 7)

ASSEMBLY

3. Tighten the previously removed hardware to secure the handle in place. See

Figure 2.

Installing the Chute

1. Place the chute handle on the lower chute as shown in Figure 3. Be certain that

the handle is aligned in the channel on the chute and the tabs snap into place.

Channel

Tab

Figure 3

2. Remove the screws in the chute base. See Figure 4.

Figure 4

NOTE: All references to the left or right side of the snow thrower are from the

operator’s position. Any exceptions will be noted.

Unpacking the Snow Thrower

1. Open the top of the carton.

2. Cut down the corners on the front of the carton and fold down the front side.

3. Pull the snow thrower out of the carton. Be sure not to damage the chute, or

any cables attached to the chute, which is shipped under the shroud on the

backside of the carton.

Assembly

Positioning the Upper Handle

1. Remove the wing knobs and carriage bolts from the top of the lower handle.

See Figure 1. It is not necessary to remove the shoulder screw and flange lock

nut below the wing knob and carriage bolt.

Perilla de aletas

Pernos del carro

Figure 1

2. Pivot the upper handle into the operating position. Be sure not to pinch any

of the cables in the process. See Figure 2.

Figure 2

1 2 3 4 5 6 7 8 9 10 11 12 ... 47 48

No comments

Craftsman 88780 Owner's Manual Page 7