Craftsman 320.2767 Operator's Manual download pdf (Page 17)

CUTTER BITS

Keep cutter bits clean and sharp. Remove all accumulated pitch and gum from

cutter bits after each use.

When sharpening cutter bits, sharpen only the inside of the cutting edge for

faster, more accurate cutting results. Never grind the outside diameter. Be sure,

when sharpening the end of a cutter bit, to grind so that the clearance angle is

the same as originally ground.

INSTALLING THE ROUTER MOTOR IN THE BASE (Fig. 5)

_, WARNING: Never use the router motor without installing it into either an

approved fixed or plunge base. Failure to do so could result in serious personal

injury and damage to motor.

WARNING: Always turn the motor off and unplug the router from the power

source before making any adjustments or installing accessories. Failure to turn

the motor off and unplug the router could result in accidental starting, which can

cause serious personal injury.

NOTE: Install the collet/nut and router cutter bit you are going to use before

installing the motor housing in the fixed base.

1. Turn the motor off and unplug the router from the power source.

2. Place the fixed base on a flat surface.

With the back of the fixed base facing

you, open the router motor clamp (A).

Press in the Coarse Adjustment Knob

(B) to separate the gears (C) while

aligning the motor housing keystrip (D)

with the keystrip-slot (E) in the fixed

base.

When the motor keystrip is aligned

and engaged into the base keystrip

slot, slide the motor down into the

fixed base.

The motor will now slide up or down

to set coarse adjustments when the

coarse adjustment knob is pressed in.

After all adjustments are made, close

the motor clamp securely.

Fig_ 5

2767 Manual_Revised_lO 1213 Page 17

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

No comments

Craftsman 320.2767 Operator's Manual Page 17