Craftsman 315.269211 Operator's Manual download pdf (Page 11)

ADJUSTRNGDEPTHOFCUT(WroTHROUTER

SeeFigure 7

The indicator point on the base can be used when

using your router mounted to a router table.

[] Set the cutter at zero depth of cut.

[] Rotate depth indicator ring to desired depth of cut

on the scale. Refer to "ADJUSTING DEPTH OF

CUT" earlier in this manual.

[] Tighten locking arm securely.

FOR ROUTER TABLE USE ONLY

iNDiCATOR

POINT

DEPTH

ADJUSTMENTRJNG

Fig. 7

ADJUSTING SPEED

See Figure 8.

Your router has a variable speed control selector

designed to allow operator control of speed and

torque limits. You can make speed selections best

suited to the type of cut, the material being cut, and

the size of bit being used. The variable speed control

selector allows you to adjust router speed from 15,000

to 25,000 RPM. There is a six=step scale (A to F) on

the variable speed control selector. To increase the

speed and torque of your router, turn the variable

speed control selector to a higher setting (F). Turn to

a lower setting to decrease speed and torque.

NOTE: If you do not want to use the variable speed

control selector, turn it to the highest possible setting,

and the feature will not be active.

The speed selection chart shown gives suggested

speed settings based on the diameter of the cutter

and the type of material being routed.

We suggest that you practice with the variable speed

feature of your router before installing a cutter and

making cuts in wood.

SPEED SELECTION CHART

CUTTER SmZE

MATERIAL 1/4 3/8 1/2 3/4

SOFT E-F D-E A-B A

MEDmUIV] D-E C-D A A

HARD C-D B-C A A

VERY HARD D-E C-D C-D B-C

Fig. 8

mNSTALUNG THE VACUUM ATTACHMENT

[] Place the vacuum attachment in the area at the

rear of the router under the locking arm.

[] Secure the vacuum attachment with the two

screws provided.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 21 22

Comments to this Manuals

No comments

Craftsman 315.269211 Operator's Manual Page 11

Comments to this Manuals

Related products and manuals for Power tools Craftsman 315.269211