Craftsman 137.216200 Operator's Manual download pdf (Page 17)

INTERIOR CUTTING (FIG. V) ....

1. Lay outthe designonthe workpiece(I). Drilla I/4"

hole inthe workpiece.

P_Wkvlv/_,Wd _11_[_

2. Release the tensionknob (2), and removethe blade (3).

Refer to BLADE REMOVAL AND INSTALLATION.

3. Place the workpieceon the saw tablewiththe

workpiecehole over the access hole(4) in thetable.

4. Installthe blade (3) throughthe hole inthe workpiece

and access hole (4) and lower the quickrelease

tensionlever(2).

5. Followthe process, items 3-g, under FREEHAND

CUTTING OPERATIONS.

6. When finished making the interiorscrollcutsturn the

scrollsaw OFF, remove the bladefrom the blade holder,

and remove the workpiecefrom the table.

Fig. V

For yourownsafety,turn the switchOFF and removethe

plug from the power source before maintainingor

lubricatingyour saw.

GENERAL

An occasionalcoat of paste wax onthe worktable will

allowthe wood beingcut to glidesmoothlyacrossthe

worksurface.

MOTOR

1. If the powercord isworn, cut, or damaged in anyway,

have it replacedimmediately.

2. Do not attemptto oil the motor bearings or servicethe

motor internal parts.

UPPER ARM BEARINGS (FIG. W)

Lubricate the upperarm bearings after every 50 hoursof

use.

1. Carefully lay the saw on its side.

2. Loosenthe bushing withan 8mm hex key.

3. Squirt a generous amount of SAE 20 (lightweight)oil (11

around the shaft end and bearing (2).

4. Let the oil penetrate the bearing assembly overnight.

5. Replace and tighten. Turnthe scroll saw over and

repeat on the other side.

Fig. W

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

No comments

Craftsman 137.216200 Operator's Manual Page 17