Craftsman 124.3299 Operator's Manual download pdf (Page 3)

SPECIAL SAFETY RULES FOR BAND SAWS

1. Always stop the band saw before removing scrap pieces from table.

2. Always keep hands and ngers away from the blade.

3. Never attempt to saw stock that does not have a at surface, unless a suitable support is used.

4. Always hold material rmly and feed it into the blade at a moderate speed.

5. Always turn off the machine if the material is to be backed out of an uncompleted cut.

6. Check for proper blade size and type for thickness and type of material being cut.

7. Make sure that the blade tension and blade tracking are properly adjusted.

8. Make “relief” cuts before cutting long curves.

9. Release blade tension when the saw will not be used for a long period of time.

10. Note and follow the safety warnings and instructions that appear on the lower door of this saw.

Never Overreach.

Keep your proper footing and balance at all times.

Never Stand on Tools.

Serious injury could occur if the tool is tipped or if the cutting tool is accidentally contacted.

Always Disconnect Tools

Disconnect tools before servicing and when changing accessories such as blades, bits, and cutters.

Always Avoid Accidental Starting.

Make sure switch is in “OFF” position before plugging in cord.

Never Leave Tools Running Unattended.

Always Wear Proper Apparel.

Never wear loose clothing or jewelry that might get caught in moving parts. Rubber-soled footwear is recommended

for the best footing.

Always Use Safety Glasses and Wear Hearing Protection.

Also use a face or dust mask if the cutting operation is dusty.

Always Check for Damaged Parts.

Before initial or continual use of the tool, a guard or other part that is damaged should be checked to assure that it

will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts,

breakage of parts, mounting, and any other conditions that may affect its operation. A guard or other damaged parts

should immediately be properly repaired or replaced.

SAVE THESE INSTRUCTIONS.

Refer to them often.

SPECIFICATIONS

Blade Length......................................................62"

Blade Width............................................1/8" to 3/8"

Throat Width...................................................8-3/4"

Cutting Depth.................................................3-1/2"

Blade Speeds.............................................1 Speed

Dust Port(1)..........................................................2"

Table Size......................................11-1/2" x 11-1/2"

Table Tilt.............................................0-45 Degrees

Motor.............................................................1/4 HP

Motor Voltage..................................................120V

Motor Amperage..............................................2.5 A

Net Weight...................................................

44 LBS

1 2 3 4 5 6 7 8 ... 41 42

Comments to this Manuals

No comments

Craftsman 124.3299 Operator's Manual Page 3

Comments to this Manuals

Related products and manuals for Power tools Craftsman 124.3299