Craftsman 315.228390 User Manual download pdf (Page 44)

TROUBLESHOOTING

PROBLEM CAUSE SOLUTION

Saw does not start.

1. Motor cord or wall cord is not

plugged in.

1. Plug in motor cord or wall cord.

2. Circuit fuse is blown.

2. Replace circuit fuse.

3. Circuit breaker is tripped.

3. Reset circuit breaker.

4. Cord or switch is damaged.

4. Have the cord or switch re

placed at your nearest Sears

Service Center.

Saw is noisy when running.

1. Motor needs attention.

1. Have the motor checked at

your nearest Sears Service

Center,

Motor is slow or weak.

1. Voltage from source is low.

1. Request a voltage check from

the power company.

2. Windings are burned out or

open.

2. Have the motor checked at

your nearest Sears Service

Center,

3. Start switch is defective.

3. Have the switch replaced.

4. Circuit is overloaded with

appliances, lights, or other

motors.

4. Do not use other appliances or

motors on the same circuit

when using the saw.

Motor overheats.

1. Motor is overloaded.

1. Request a voltage check from

the power company.

2. Dull blade.

2. Replace the blade.

3. Sawdust inside saw is blocking

air flow.

3. Clean out the saw base.

Motor stalls, blows fuses, or trips

circuit breakers.

1. Starter switch is defective.

2. Voltage from source is low.

1. Have the switch replaced.

2. Request a voltage check from

the power company.

3. Dull blade.

3. Replace the blade.

4. Fuses or circuit breakers are

wrong size or defective.

4. Replace fuses or circuit

breakers.

5. Feeding workpiece too rapidly.

5. Feed workpiece into blade

slower.

CRflFTSMftN TABLE SAW 315.228390 44

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 65 66

Comments to this Manuals

No comments