MANUAL,MODEL N@o351 °22532CAUTION:READ ALLgNSTRUCTgONSCAREFULLy!and MITERoassembly'ooperating, repair partsi . i,,Sold by SEARS, ROEBUCK AND CO.,
USING THE MITER GUAGEThe miter gauge is used only on the disc table. Usethe miter gauge for securing work and holding the pro*per angle, while disc sa
TROUBLE SHOOTINGWARNING: FOR SAFETY, TURN SWITCH "OFF"AND ALWAYS REMOVE PLUG FROM POWERSOURCE OUTLET BEFORE TROUBLE SHOOTING.TroubleMotor wi
REPLACEMENT PARTS LISTKEYNO_1234567891011121314151617181920212223242526272829303132333435363738394O4142434445PART NO.1381,00133600STD55t125STD541025ST
REPLACEMENT PARTS LIST (Continued)KEYNO,464748495O515253545556575859606162636465666768697O7172737475767778798O8182838485868788PART NO.1387 00141900138
19212O497O/4 3 646935 384539624O3O5OFigure 6
777174 73764779723O573O493o !359\ ,.\563552549598680_ 87. 883498I0
MODEL NO.351.22632TO ORDERREPAIR PARTSNow that you have purchased your Belt and Disc Sandershould a need exist for repair parts or service, simply con
FULL ONE YEAR WARRANTY ON SEARS CRAFTSMANIf within one year from the date of purchase, this Sears Craftsman Belt & Disc Sander fails due_=< to
CONTENTSWarranty ... 2General Safety Instructionsfor Power Tools ...
MOTOR SPECIFICATOONS AND ELECTRICAL REQUIREMENTSMOTORThe Belt and Disc Sander is assembled with motor andwiring installe&The 120 Volt AC capacitor
ELECTRICAL CONNECTIONSWARNING: MAKE SURE THE UNIT IS "OFF" ANDDISCONNECTED FROM THE POWER SOURCEBEFORE INSPECTING ANY WIRING.The motor and w
TOOLS NEEDEDJ10-12-14mmWRENCHES/#2 PHILLIPSSCREWDRIVER10-12-"SOCKETS &RATCHETHANDLEASSEMBLY(Refer to figure 6)The frame (Key No_ 77) and the
FASTEN THE BELT GUARD1 The rear belt guard (Key No 45) and screw (Key No48) should be unattached_2 Hold the belt guard with the drive pulley end up an
OPERATDNG INSTRUCTIONSSAFETY PRECAUTIONSWARNING: ALWAYS OBSERVE THE FOLLOW-ING SAFETY PRECAUTIONS.Whenever adjusting or replacing any parts on thesand
ADJUSTING BELT TABLE ANGLETo adjust the angle of the belt table, loosen the sockethead bolt (Key No 52) and adjust to the desired angleUse a combinati
Comments to this Manuals