Craftsman 351.217220 Operator's Manual download pdf (Page 10)

• Retighten chain using idler bracket. Tighten socket

head bolt securely.

• Set the planer back on its base.

• Make a test cut to verify adjustment.

REPLACING V-BELT

Refer to Figure 20, page 16.

Inadequate tension in the V-belt (Key No. 49) will cause

the belt to slip from the motor pulley (Key No. 46) or

cutterhead pulley (Key No. 48). Loose belt must be

replaced. To replace V-belt:

• Turn planer off and unplug from power source.

• Remove socket head bolts from belt guard (Key Nos.

3 and 35). Remove belt guard.

• Loosen pan head screw on dust chute (Key Nos. 59

and 60). Remove dust chute.

• Remove screws from fan cover (Key Nos. 54 and

53). Remove fan cover.

• Remove pan head screw and flat washer from fan

(Key Nos. 18, 51 and 52). Remove fan.

IMPORTANT: Note position of indicator, last step is

resetting the indicator to this position.

• Remove pan head screws and flat washer from indi-

cator and fan housing (Key Nos. 18, 51, 50 and 58).

Remove fan housing.

• Loosen hex head bolt (Key No. 38) to release motor.

• Replace belt. Make sure new belt is evenly seated all

the way on the motor and cutterhead pulley grooves.

• Pull top of motor toward front of planer to tension V-

belt, tighten hex head bolt securely. Check tension in

V-belt by pinching the two sides of belt loop. Sides

should give no more than '/2".

• Replace and secure fan housing (all screws except

screw for indicator).

• Insert fan onto fan shaft (Key No. 55) and rotate fan

until it seats. Replace pan head screw with flat wash-

er and tighten securely.

• Replace and secure fan cover, then dust chute.

Replace and secure belt guard.

• Align indicator with hole in fan housing. Insert pan

head screw with flat washer but do not tighten. Align

indicator to original position and tighten pan head

screw securely.

LUBRICATION

• Motor and cutterhead bearings are sealed and need

no lubrication.

• Gears and elevation screws should be cleaned of

debris and greased as needed.

• The table can be coated with a lubricant such as fur-

niture wax, to make the workpiece feed smoother. Be

sure the lubricant used does not affect the ability to

finish the workpiece with varnish, sealer, etc. Do not

use any silicone base lubricants.

CLEAN PLANER

• Keep planer clean of any wood chips, dust, dirt or debris.

• Remove blade guard and fan cover (Fig. 20, Key

Nos. 1 and 53) to clean dust collection system.

• After 10 hours of operation, the chains and gears

should have wood chips, dust and old grease

removed.

• Use common automotive bearing grease to lubricate

all chains and gears. Be sure all chains and gears

have plenty of grease.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Comments to this Manuals

No comments

Craftsman 351.217220 Operator's Manual Page 10

Comments to this Manuals

Related products and manuals for Power planers Craftsman 351.217220

Powiązane produkty i podręczniki dla Ekwipunek Grain-systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-