Craftsman 875.191173 User Manual download pdf (Page 3)

_. Morethan1/100slope

_BFranchne 2tmes__-r'_St_ _-__er Mainline=3times

_f ...... = • / P Reaulator Toolinlet/hosesize

II Iool,n,el:,noses,ze _,_c-Jtor ",_

II ,bF

_Auto Drain 111,....7Air Tool ............................:

_ Valve Air Compressor

Figure 1

Air Hose Hook Up

WARNING: DISCONNECTTOOL FROM AIR SUPPLY

BEFORE SERVICING OR CHANGING SOCKETS. This

ratchet is equipped with a lever throttle which allows the

operator to vary the speed. Direction control is located on

the back of the ratchet head. Initial tightening and loosen-

ing of fasteners should be done manually with ratchet

used as a hand tool. Fasteners may then be run on and

off with relative ease.

Keep socket firmly against work surface when running the

ratchet to avoid dislodging the socket from the anvil.

Excessive torque leverage above tool specifications will

result in premature gear wear.

Lubrication

An in-line filter-regulator-lubricator (fig 1) is recommended

as it increases tool life and keeps the tool in sustained

operation. The in-line lubricator should be regularly

checked and filled with air tool oil. Proper adjustment of

the in-line lubricator is performed by placing a sheet of

paper next to the tools exhaust ports and holding the

throttle open approximately 30 seconds. The lubricator is

properly set when a light stain of oil collects on the paper.

Excessive amounts of oil should be avoided.

In the event that it becomes necessary to store the tool for

an extended period of time (overnight, weekend, etc.), it

should receive a generous amount of lubrication through

the air inlet (fig 2). The tool should be run for

approximately 30 seconds to ensure oil has been evenly

distributed throughout the tool. The tool should be stored

in a clean and dry environment.

Air Inlet

Recommended lubricants: Use air tool oil or any other

high grade turbine oil containing moisture absorbent, rust

inhibitors, metal wetting agents and an EP (extreme

pressure) additive. (See Fig. 2 for location/air inlet).

Figure 2

1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments

Craftsman 875.191173 User Manual Page 3

Comments to this Manuals

Related products and manuals for Power impact wrenches Craftsman 875.191173