Craftsman 919.679370 Owner's Manual download pdf (Page 13)

13 — ENG

MAINTENANCE

Note 1: Change oil after first five (5) operating hours and every 50 operating hours thereafter, more often if operated in

extreme dusty or dirty conditions.

Note 2: Check oil after 5 hours of operation (See page 14 - ENGINE MAINTENANCE - Changing Engine Oil.)

Connecting Electrical Loads

• Let engine run and warm up for about five minutes

after starting.

• Plug in the desired 120 or 240 volts tools.

• DO NOT connect 240 volt equipment to the 120 volt

duplex receptacles.

• DO NOT connect 3-phase loads to the panel

receptacles.

IMPORTANT: You should always add up the rated

watts of all lights, tools and appliances you are pow-

ering at one time. This total should not exceed the

rated capacity of your generator or circuit breaker rat-

ing of the receptacle supplying power.

Stopping The Engine

• Disconnect all electrical loads.

• Switch the start/off switch to the off position.

IMPORTANT: Never store engine with fuel in tank,

indoors, or in enclosed, poorly ventilated areas or

where fuel fumes may reach an open flame.

CUSTOMER RESPONSIBILITIES TABLE

MAINTNENANCE TASK

Before each

use

Every 25

Hours of Every

Season

See Note 2

Every 50

Hours of Every

Season

See Note 1

Every 100

Hours of Every

Season

Check oil level

Change oil

Clean Air Filter Assembly

Check Spark Plug

Prepare Unit for Storage

Prepare unit for storage if it is to remain idle for more than 30 days.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 37 38

Comments to this Manuals

No comments

Craftsman 919.679370 Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Power generators Craftsman 919.679370