Craftsman 973.111400 Owner's Manual

Owner's ManualIrRRFT MRN°I3/8 in. CORDLESS DRILL-DRIVERVariable Speed / ReversibleModel No.973.111400Save this manual forfuture referenceCAUTION:

INSTALLING BITSSee Figure 8.• Lock the switch trigger by placing the direction ofrotatmn selector in center position. See Figure 5.Ii Open or close ch

Note: Remember the two-speed feature (HI-LO) whensetting torque. The amount of torque will vary depend-ing on which speed setting you have your drill-

CHUCK REMOVALSee Figures 14. 15, and 16.The chuck must be removed in order to use someaccessories. To remove:• Lock the switch trigger by ptacing the

_IL WARNING: When servicing, use only identicalCraftsman replacement parts. Use of any otherpart may create a hazard or cause productdamage,Avoid usin

To preserve natural resources, pleaserecycle or dispose of batteriesproperly.This product contains nickel-cadmium batteries. Local, state orfederal la

CRAFTSMAN 3/8 in. CORDLESS DRILL-DRIVER- MODEL NO, 973.111400The model number will be found on a plate attached to the motor hous{ng. Always mention t

• Warranty ...

The purpose of safety symbols is to attract your attention to possible dangers. The safety symbols, andthe explanations with them, deserve your carefu

RULES FOR SAFE OPERATION (Continued)• NEVER USE IN AN EXPLOSIVE ATMOSPHERE.Normal sparking of the motor could Ignite flam-mable liquids, gases, or fum

RULES FOR SAFE OPERATION (Continued)• An extension cord should not be used unlessabsolutely necessary. Use of improper extensioncord could result in a

Thefollowing recommended accessories are currently available at Sears Retail Stores.• 6-Pc, Extra Length Magnite Power Bit Set • High Speed Bits (For

_i WARNING: Always wear safety goggles orsafety glasses with side shields when operatingtools. Failure to do so could result in objectsbeing thrown in

SWITCHSee Figure 2,To turn your drill ON, depress the switch trigger. Toturn it OFF. release the switch trigger.SWTCHJ TRIGGER_SELECTORFig. 2VARIABLE

SWITCH LOCKSee Figure 5.The switch trigger can be locked in the OFF position,This feature can be used to prevent the possibility ofaccidental starting