Craftsman 315.341300 Operator's Manual

19.2 VOLT CHAIN SAWMOTOSIERRA DE 19,2 VModel No.315.341300Número de modelo 315.341300987000-68005-01-09 (REV:02)OPERATOR’S MANUALMANUAL DEL OPERADORSa

10 - EnglishASSEMBLYUNPACKINGThis product has been shipped completely as-sembled. Carefully remove the product and any acces-sories from the box. M

11 - EnglishOPERATIONFor complete charging instructions, refer to the Operator’s Manual for your Craftsman battery pack and charger models.TO INSTALL

12 - EnglishOPERATIONPREPARATION FOR CUTTINGPROPER GRIP ON HANDLESSee Figures 8 - 10.Refer to GENERAL SAFETY RULES earlier in this manual for appropri

13 - EnglishOPERATIONTREE FELLINGSee Figures 12-16.Unusual Hazardous Tree Felling ConditionsDo not fell trees during periods of high wind or heavy pre

14 - EnglishOPERATION As tree starts to fall, stop the chain saw and put it down immediately. Retreat along the cleared path, but watch the action in

15 - EnglishOPERATION Limbs should be cut one at a time. Remove the cut limbs from the work area often to help keep the work area clean and safe. Br

16 - EnglishMAINTENANCEWARNING: When servicing, use only identical replacement parts. Use of any other parts may create a hazard or cause p

17 - EnglishMAINTENANCEREPLACING BAR AND CHAINSee Figures 24 - 28.WARNING: Remove the battery pack from the chain saw and make sure the chain

18 - EnglishMAINTENANCE During normal saw operation, the temperature of the chain will increase. The drive links of a correctly tensioned warm chain

19 - EnglishSIDE PLATE ANGLESee Figure 36. CORRECT - 80° Produced automatically if correct diameter file is used in file holder. HOOK - “Grabs” an

2TABLE OF CONTENTS / ÍNDICE DE CONTENIDOWARRANTY / GARANTÍAINTRODUCTION / INTRODUCCIÓNThis tool has many features for making its use more pleasant an

20 - EnglishTROUBLESHOOTINGPROBLEM CAUSE SOLUTIONBar and chain running hot and smoking. Motor runs, but chain is not rotating.1. Check chain tens

iBAFig. 1AAFig. 2A - Kickback danger zone (zona de peligro de contragolpe)Fig. 3A - Rotational kickback (contragolpe rotatorio)A - Pull (tirón)B - Pus

iiFig. 5A - Battery port (receptáculo de las pilas)B - Latches (pestillos) C - Battery pack (paquete de pilas)Fig. 6CBAABFig. 7A - Trigger lock-out bu

iiiAB45°45°90°135°135°BFig. 13A - Planned line of fall (línea planeada de caída)B - Safe retreat zone (zona de retirada segura) ACBFig. 14A

ivFig. 21A - Second cut (segundo corte)B - Load (carga) C - First cut 1/3 diameter (primer corte 1/3 del diámetro)D - Finishing cut (corte final

vA - Cutting corner (esquina de corte)B - Top plate (placa superior)C - Rivet hole (orificio del remache)D - Heel (talón)E - Gullet (garganta)F - Toe

viFig. 39AA - Restore original shape by rounding the front (restablezca la forma original redondeando la parte frontal)AFig. 40A - Lubricating ho

21 - English Key Part No. Number Description Qty. 1 31119329G Chain Oil Tank Cap Assembly ...

23 - EnglishNOTES

22 - EnglishNOTES

3 - EnglishWARNING: Read and understand all in-structions. Failure to follow all instructions listed below may result in electric shock, fi

21 - Español® Registered Trademark / TM Trademark /SM Service Mark of Sears Brands, LLC ® Marca Registrada / TM Marca de Fábrica / SM Marca de Servici

4 - EnglishGENERAL SAFETY RULES Always wear eye protection with side shields marked to comply with ANSI Z87.1, along with hearing and head protection

5 - EnglishGENERAL SAFETY RULES When cutting a limb that is under tension, be alert for spring back so that you will not be struck when the tension i

6 - EnglishSPECIFIC SAFETY RULESBATTERY SAFETY Battery operated units do not have to be plugged into an electrical outlet; therefore, they are always

7 - EnglishBar Tip GuardAn attachment that may be provided on the end of the guide bar to prevent the chain at the end of the guide bar from contactin

8 - EnglishSYMBOLSThe following signal words and meanings are intended to explain the levels of risk associated with this product.SYMBOL SIGNAL MEANIN

9 - EnglishSYMBOLSFEATURESPRODUCT SPECIFICATIONSMotor ............ 19.2 Volt DCBar Length .......