Craftsman 486.24612 Owner's Manual

Owner's IVlanuai®FRONT U EIVlodel Nos. 486.24611,486.24612Fits 247 and 917 Series LT/GT TractorsDO NOT RETURN TO STOREFor Missing Parts or Assemb

TRACTORS WITH FRAME SHOWN iN FIGURE 1BSTEP 1: (SEE FIGURE 2)* Open parts bag labelled "A" and verify that all partsare present.NOTE: Place c

STEP 3: (SEE FIGURE 4)* Assemble a 3/8 × 1" hex bolt and 3/8" whizlock nut totractor frame and middle slot of the bumper.* Tighten and then

Your HomeFor expert troubleshooting and home solutions advice:www.managemyhome.comFor repair - in your home - of all major brand appliances,lawn and g

WARRANTYCRAFTSMAN ONE-YEAR FULL WARRANTYWhen assembled, operated and maintained according tothe supplied instructions, if this product fails due to a

DETERMINE IFYOUR TRACTOR HAS A SINGLE SUSPENSION BRACKET "_OR DUAL SUSPENSION BRACKETS JSINGLE SUSPENSIONBRACKETtSUSPENSIONBRACKETFIGURE 1A (page

STEP 2: (SEE FIGURE 3)* Remove tractor hood. (Refer to tractor manual.)* Remove the browning shield as shown.REMOVEFRONT SCREWSREMOVEBROWNING SHIELDFI

STEP 6: (SEE FIGURE 7)* Replace the browning shield using the front screwsyou removed in Step 2.REPLACEFRONT SCREWSREPLACEBROWNING SHIELD IFIGURE 7(iN

STEP 2: (SEE FIGURE 3)* Remove tractor hood. (Refer to tractor manual.)* Remove an (LT) Lawn Tractor heat shield like the oneshown. Remove a (GT) Gard

STEP 4: (SEE FIGURE 5)* Remove any bolts present infront mounting holes inside of tractor frame. If bolt will not screw out of hole,check if a nut is

(iDENTiFY YOUR TRACTOR FRAME)For all tractors with model numbers beginning with 247, look at the side of your tractor directly underneath the hood (Fi

STEP 2: (SEE FIGURE 3)* Place plug on a work bench or solid table and pushend of bumper down onto plug. Repeat for all plugs.BUMPERPUSH DOWNWiTH EVENP