Craftsman 320.48251 Operations Instructions download pdf (Page 9)

USING THE LASER TRAC TM LEVEL (cont.)

USING AS A WALL-MOUNTED LEVEL (See Figures 14 to 17)

This level can also be wall-mounted using the special base included.

Figures 14 and 15 show the top and bottom views of the Thin-Pin Wall-Mount

Base° Figure 14 also shows the protective cover that snaps into the bottom of

the base when it is not in use.

There are two red buttons on the top of the base (see Fig° 14) that are used to

push the thin pins out of the base.

The thin pins (shown in Figure 15) can be driven into any softer wood or

wal!-board surface to secure the level,,

The thin pins in this base are designed to be easily removed from the

wood or wall-board surface.

This base also has an alignment pin for pivoting the tool on the base to aid in

referencing two points (see Fig. 14),_

Fig. 14

Alignment Pin

Red Buttons

Protective Cover

Fig. 15

Level

Thin Pins

Alignment Pin

MOUNTING LEVEL TO THIN-PIN WALL MOUNT BASE

(See Figures 16 and 17)

1. Place level on the Thin-Pin Wall-Mount Base and slide either the front or back

of the tool into and around the alignment pin°

2. Switch the level "on'L DO NOT point the tool in the direction of your eyes or

anyone else's in the vicinity of use.

3. Place the level and wall-mount assembly on a soft wood or wallboard surface

(see Fig. 16).

4. Align the laser line with any two measured or leveled reference points or

level tool using built-in level vials for vertical or horizontal lines.

5. Push the thin pins into the surface using the red buttons on the base plate.

The Laser Trac TM Level can be used to align a single object or objects on one

surface as shown in Figure 16.

However its most effective use is for aligning multiple objects on multiple

surfaces such as the alignment of bath fixtures in a tub enclosure as shown in

Figure !7.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

No comments

Craftsman 320.48251 Operations Instructions Page 9