Instruction Manual25CC/1.5 cu.in. 2-Cycle17 Inch Cutting Path / 0.080 In. LineGASOLINE WEEDWACKER®For Occasional Use OnlyA9WARNING:Read and follow all
SERVICE AND ADJUSTMENTSLINE REPLACEMENTPre-wound spools offer the most convenient method for replacing line and ensuring optimum performanc
Turn idle speed screw counterclockwise to decrease engine speed.If you require further assistance or are unsure about performing this procedure,
TROUBLESHOOTING TABLEdk WARNING: Always stop unit and disconnect spark plug before performing all of the recommended remedies below
or workmanship of the engine causes the failure of such an emission reiafed part, the part wiii be repaired or replaced by Sears. OWNER’S WARRANTY R
TABLE OF CONTENTSWarranty Statement 2 Storage 11Safety Rules 2 Troubleshooting Chart 12Assembly 4 Emissions Statement 12Operation 5 Parts List 14Maint
If situations occur which are not covered in this manuai, use care and good judgment. If you need assistance, contact your Sears Service Center or c
• StorG unit and fuel in area where fuel vapors cannot reach sparks or open flames from water heaters, electric motors or switches, furnaces, etc.•
For proper orientation of shield, see KNOW YOUR TRIMMER illustration in OPERATION section.1. Remove wing nut from shield.2. insert bracket into slo
engine oil. We recommend Craftsman brand synthetic oil. Mix gasoline and oil at a ratio of 40:1. A 40:1 ratio is obtained by mixing 3.2 ounces of oil
STARTING A WARM ENGINE1. Move ON/OFF switch to the ON position.2. Move the choke lever to the HALF CHOKE position.3. Squeeze and hold the throttle
> The tip of the line does the cutting. You will achieve the best performance and minimum line wear by not crowding the line
MAINTENANCEMAINTENANCE SCHEDULEA WARNING: Disconnect the spark plug before performing maintenance except for carburetor adjustments.CARE & MAINTEN
Comments to this Manuals