Craftsman 247.298760 User Manual download pdf (Page 8)

C. Secure with hex center locknut (G). See figure

Pivot Arm

Assembly

FIGURE 11.

FIGURE 9.

H^^NOTE

Tighten hex locknut just to the point

the rubber washer starts to

conn press.

4. Control Rod.

A. Place control rod through slot in handle panel,

hook end of rod goes towards the front of

tiller. See figure 10.

FIGURE 10.

B. Hook control rod in hole provided on pivot arm

assembly as shown In figure 11. Secure

control rod to pivot arm assembly with hair pin

cotter (C). See figure 11.

C. Please note there are three holes left on the

shift lever. Use the second hole from bottom

for the next step. See figure 12.

Shift Lever

Second Hole

From Bottom

FIGURE 12.

D. Place shift lever in first gear and thread ferrule

(D) on end of control rod until ferrule lines up

with second hole on shift lever. See figure 13.

Secure with hair pin cotter (C). See figure 13.

FIGUREIS.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

No comments

Craftsman 247.298760 User Manual Page 8