Craftsman 247.797851 Owner's Manual download pdf (Page 9)

• Pull rope with a rapid, continuous, 1oil arm stroke

Keep a firm grip on start handle Let rope rewind

slowly Do not tet starter handie snap back against

starter

e Repeat preceding two instructions until engine fires

When engine starts, move choke lever on engine

halfway between CHOKE and RUN

NOTE: If engine does not tire after three attempts,

move choke lever halfway between CHOKE and RUN

position and try again See figure 9

Chok? jLZ "_

oFF

Throttle Control

FIGURE 9..

e Move throttle contro! to IDLE position for a few

minutes warm-up Move choke lever 1o RUN posi-

tion as engine warms up

NOTE: In order to idle smoothly, a new engine may re-

quire 3 to 5 minutes running above stow idle speed

idle speed has been adjusted to be correct after this

break-in period

TO STOP ENGINE

o Move throttle control lever to STOP position See

figure 9.

o Disconnect spark plug wire and move away from

spark plug to prevent accidental starting while equip-

ment is unattended.

HOW TO USEYOUR CHIPPER-SHREDDER

Do not attempt to shred or chip any material other than

vegetation found in a normal yard (leo, branches,

leaves, twigs, etc.)

The chipper-shredder is designed lot three different

methods o1 operation

@ Leaves and small branches up to 1/2" diameter can

be fed into the hopper assembly when it is in the

raised position See figure !0 If it becomes

necessary to push material into the chipper-

shredder, use a small diameter stick--NOT YOUR

HANDS The stick should be small enough that it

will be ground up if gets into the impeller assembly

WARNING: DO NOT PUT MATERIAL

LARGER THAN 1/2" IN DIAMETER INTO

THE HOPPER ASSEMBLY, MATERIAL UP

TO A MAXZIMUM OF 3" IN DIAMETER

MATERIAL MAY BE FED INTO THE

CHIPPER CHUTE. DO NOT ATTEMPT TO

SHRED OR CHIP ANY MATERIAL

LARGER THAN 3" IN DIAMETER.

PERSONAL INJURY OR DAMAGE TO

THE MACHINE COULD RESULT°

opper

Assembly

FIGURE 18.

Leaves and small twigs can be raked into the hop-

per assembly when the hopper assembly is lowered

to the ground See figure 11 Small branches up to

tt2" diameter can also be fed into the hopper

assembly in this position See figure 12

WARNING: THE CHIPPER-SHREDDER

DISCHARGES MATERIALS WITH CON*

SIDERABLE VELOCITY, KEEP AWAY

FROM THE AREA AROUND THE CHUTE

DEFLECTOR,, ALWAYS STOP THE

ENGINE AND DISCONNECT THE SPARK

PLUG WIRE WHEN REMOVING OR AT-

TACHING THE BAG WHEN CHANGING

CONTAINERS OR WHEN REMOVING THE

SHREDDED MATERIAL, WEAR SAFETY

GLASSES AND GLOVES WHENEVER

USING YOUR CHIPPER-SHREDDER.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

No comments

Craftsman 247.797851 Owner's Manual Page 9

Comments to this Manuals

Related products and manuals for Garden shredders Craftsman 247.797851