Craftsman Garage Door Opener Owner's Manual download pdf (Page 8)

ASSEMBLY STEP 3

Fasten T-Rail to Opener

USE ONLY THOSE SCREWS MOUNTED IN TOP

OF OPENER. FAILURE TO DO SO WILL CAUSE

SERIOUS DAMAGE TO OPENER.

CAUTION: USE ONLY THESE SCREWS! Use of any

other screws will cause serious damage to door

opener.

Insert a 5/16"-18x7/8" hex screw into trolley stop hole in

T-rail as shown. Tighten securely with a 5/16" lock

washer and nut.

ASSEMBLY STEP 2

Assemble & Install Trolley

AS A TEMPORARY STOP, INSERT A

SCREWDRIVER INTO HOLE IN FRONT END OF T-

RAIL.

Attach threaded shaft to trolley with lock washer and

nuts as shown.

Slide trolley assembly along rail to screwdriver stop.

NOTE: If trolley hits against nut on T-rail, bolts

and nuts were attached from the wrong side and

must be repositioned. Review Step 1.

PROCEDURE: Place the opener on packing material to

protect the cover. For convenience, place a support

under the cable pulley bracket.

Remove the (2) 5/16"-18x1/2" washered screws mounted

in the top of the opener. Align holes in back end of T-rail

with holes in opener. Fasten the rail with the (2) washered

screws previously removed and tighten securely.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

No comments

Craftsman Garage Door Opener Owner's Manual Page 8