Craftsman 57918 Owner's Manual download pdf (Page 39)

Door Control

SYNCHRONIZE THE DOOR CONTROL

To synchronize the door control to the garage door opener, press

the push bar until the garage door opener activates (it may take

up to 3 presses). Test the door control by pressing the push bar,

each press of the push bar will activate the garage door opener.

USING THE DOOR CONTROL

LIGHT

Button

HOLD Button for

the Timer-To-Close

(TTC)

Motion

Sensor

Push Bar

1 Minute,

5 Minute,

and 10

Minute TTC

LED

Push Bar

Press the push bar to open or close the door.

Light Button

Press the LIGHT button to turn the garage door opener lights on

or off. When the lights are turned on they will stay on until the

LIGHT button is pressed again, or until the garage door opener is

activated. Once the garage door opener is activated the lights will

turn off after the specified period of time (the factory setting is 4-

1/2 minutes). The LIGHT button will not control the lights when

the door is in motion.

The duration of the light timing can be adjusted using the door

control.

LEARN A DEVICE

Any compatible remote controls, wireless keyless entry, or Smart

Control accessories can be programmed to the garage door

opener by pressing the LEARN button on the Motion-Detecting

Control Panel.

Lock

The LOCK feature is designed to prevent activation of the garage

door opener from remote controls while still allowing activation

from the door control and keyless entry. This feature is useful for

added peace of mind when the home is empty (i.e. vacation).

Timer-to-Close (TTC)

DO NOT enable TTC if operating a one-piece door. TTC is to be

used ONLY with sectional doors.

Factory default is set to off. TTC can be set to automatically close

your garage door from the fully open position after a specified

period of time (1, 5, 10 minute intervals). The garage door opener

will beep and the lights will flash before closing the door. If the

door encounters an obstruction while closing, the garage door

opener will make a second attempt to close the door. If the

obstruction has not been cleared after the second attempt, the

garage door opener will reverse open, stop and WILL NOT close

until the obstruction has been cleared. TTC WILL NOT work if the

garage door opener is operating by battery power or if the safety

reversing sensors are misaligned. This feature is NOT intended to

be the primary method of closing the door. A keyless entry

should be installed in the event of an accidental lock out

when using this feature.

AUTOMATIC LIGHT

Motion Sensor

Factory default is set to on. This feature will automatically turn on

the garage door opener lights when motion is sensed. The lights

will come on for the set period of time, then shut off.

If using the garage door opener light as a work light disable the

Automatic Light Feature, otherwise the light will turn off

automatically if you are beyond the range of the sensor.

Light Feature

The lights will turn on when someone enters through the open

garage door and the safety reversing sensor infrared beam is

broken.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 95 96

Comments to this Manuals

No comments

Craftsman 57918 Owner's Manual Page 39

Comments to this Manuals

Related products and manuals for Garage Door Opener Craftsman 57918