Craftsman 536.88123 User Manual download pdf (Page 7)

Place yoke end of crank rod around uni

versal joint, lining up openings, insert

clevis pin through assembly and secure

with cotter pin. Spread ends of cotter pin

to lock in place. See figure below.

Tighten nut on eye bolt, keeping eye in

line with the rod while tightening №e inside

securely.

Tighten all handle bolts with a 9/16"

wrench.

\ Crank Rod

Cotter pin Assembly

Universal joint

pin

Universa! joint

^Wonm Mounting

ASSEMBLE sVibw

* Remove back carriage bolt, see figure

below.

Carriage-

Bolt

Tilt chute back into operating position.

NOTE: DO NOT cut tie strap located on

chute deflector at this time.

• Push remote chute control lever into

"Chute Deflector Down“ position.

• Cut tie strap on chute deflector as shown

in figure below.

Replace carriage bolt.

Tighten carriage bolt securely. NOTE:

Check all bolts in chute ring for tightness.

Remove and discard packaging used to

protect chute.

SPEED SELECTOR ROD

• Cut plastic tie securing shifter lever

assembly to the shifter bracket. See

figure below.

Remove locknut, washer, spring and the

bolt. See figure below.

Plastic Knob

(pointed forward)

Control

Panel

.3/8-16 Hex Jam Nut

Shifter Bracket

ocknut

Spring

1/8 to 3/8

inch of

Exposed

Thread

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comments to this Manuals

No comments