Craftsman 919.167462 Owner's Manual download pdf (Page 18)

Before you store the air compressor,

make sure you do the following:

Review the "Maintenance"

section on the preceding pages

and pe_orm scheduled

maintenance as necessary.

2. Set the On/Auto/Off lever to

"OFF" and unplug unit.

3. Turn the regulator

counterclockwise and set the

outlet pressure to zero.

4. Remove the air tool or accessory.

Pull ring on safety valve allowing

air to bleed from the tank until

tank pressure is approximately

20 psi. Release safety valve ring.

6. Drain water from air tank by

opening drain valve on bottom

of tank.

I_ Risk of Bursting.

Water will

condense in the air tank. If not

drained, water will corrode and

weaken the air tank causing a risk

of air tank rupture.

7. After the water has been drained,

close the drain or drain valve.

NOTE: If drain valve is plugged,

release all air pressure. The valve

can then be removed, cleaned, then

reinstalled.

Protect the electrical cord and air

hose from damage (such as

being stepped on or run over).

Wind them loosely around the

compressor handle.

Store the air compressor in a

clean and dry location.

D30050 18_ ENG

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 47 48

No comments

Craftsman 919.167462 Owner's Manual Page 18