Instruction ManualI CRAFTSMAN°I25cc/1.5 cu.in. 2-Cycle205 MPH/410 CFMGASOLINE POWEREDBLOWER/VACModel No.358.797340• Safety• Assembly• Operation• Maint
REPLACE SPARK PLUGReplace spark plug each year to en-sure the engine starts easier and runsbetter. Set spark plug gap at 0.025inch. Ignition timing is
We recommend all service and adjust-ments not listed in this manual be per-formed by your Sears Service Center.CARBURETOR ADJUSTMENTCarburetor adjustm
A_, WARNING: Perform the followingsteps after each use:• Allow engine to cool, and secure theunit before storing or transporting.• Store unit and fuel
TROUBLESHOOTING TABLEWARNING: Always stop unit and disconnect spark plug before perform-ing any of the recommended remedies below other than remedies
MANUFACTURER'S WARRANTYCOVERAGE: If any emissions relatedpart on your engine (as listed underEmissions Control Warranty Parts List)is defective o
Warranty Statement 2 Storage 12Safety Rules 2 Troubleshooting Table 13Assembly 4 Emissions Statement 13Operation 6 Parts List 15Maintenance 9 Spanish
• Do not operate unit when you aretired, ill, upset, or if you are under theinfluence of alcohol, drugs, or medi-cation.• Keep children, bystanders, a
• Empty fuel tank before storing theunit. Use up fuel left in carburetor bystarting engine and letting it run untilit stops.• Do not use any accessory
2. Push the small end of the elbowtube through the small opening inthe bag.ElbowTubeSmallOpeningZipperOpening RibNOTE: Make sure edge of the smallopen
SHOULDER STRAP ADJUSTMENT(for vacuum use only)1. Hold the unit as shown.2. Pass the shoulder strap over yourhead and onto your right shoulder.3. Exten
OPERATING TIPS• While vacuuming or blowing debris,hold the unit with the muffler side fac-ing away from your body and clothes(see OPERATING POSITION).
STARTING THE ENGINE_,WARNING: You MUST make surethe tubes are secure before using theunit.• Fuel engine. Move at least 10 feet (3meters) away from the
CUSTOMER RESPONSIBILITIESCARE & MAINTENANCE TASKCheck for loose fasteners and partsCheck for damaged or worn partsInspect and clean unit and label
Comments to this Manuals